Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:body02 [2019/05/10 06:04] ixl2relax [Petcock (Fuel Outlet)] |
techtalk:evo:body02 [2020/03/23 13:36] hippysmack [FENDERS] |
||
---|---|---|---|
Line 77: | Line 77: | ||
===== Petcock (Fuel Outlet) ===== | ===== Petcock (Fuel Outlet) ===== | ||
+ | {{:techtalk:evo:body:petcock_function_1_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) \\ | ||
\\ | \\ | ||
Line 83: | Line 84: | ||
===== Vapor Valve (Tank Venting) ===== | ===== Vapor Valve (Tank Venting) ===== | ||
+ | From the 2003 Sportster Service Manual | ||
+ | |||
+ | (Fuel Tank section) | ||
+ | |||
+ | "The fuel tank is vented through a standpipe (vent tube) within the tank. A hose at the base of the fuel tank is connected to the standpipe." | ||
+ | |||
+ | "The fuel tank vapor hose is connected to a vapor valve located beneath the seat between the oil tank and the battery tray. ON non-California models, another hose connects the vapor valve bottom fitting to a hollow frame member. On California models, the bottom hose is routed to the carbon canister." | ||
+ | |||
+ | "Mount the vapor valve in an upright position with the longer fitting positioned at the top or excessive fuel vapor pressure may build up within the fuel tank." | ||
+ | |||
+ | (CA EVAP section) | ||
+ | |||
+ | "If the vehicle is tipped at an abnormal angle, the vapor valve closes to prevent liquid gasoline from leaking out of the fuel tank through the vent hose." | ||
\\ | \\ | ||
Line 90: | Line 104: | ||
====== FENDERS ====== | ====== FENDERS ====== | ||
+ | |||
+ | **2005 XL Model Wire Harness Elbow**: ((HD TECH Tip (TT059) dated May 5, 2009)) \\ | ||
+ | If you remove the RH wire harness elbow (73205-05), it is recommended to install washer (6859M) on the mounting bolt when reinstalling the elbow. \\ | ||
+ | This is to prevent future damage to the elbow’s mounting hole. \\ | ||
+ | This washer was installed in production as of February 27, 2005. \\ | ||
+ | |||
\\ | \\ |