Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:body04 [2019/06/18 09:55] ixl2relax [Throttle Cables] |
techtalk:evo:body04 [2019/10/06 23:50] ixl2relax [Throttle Cables] |
||
---|---|---|---|
Line 155: | Line 155: | ||
Route the throttle cable in a similar manner into the side slot of the bracket and make sure the cable sheath fits down into the bracket cup (there is no spring on the throttle cable end). | Route the throttle cable in a similar manner into the side slot of the bracket and make sure the cable sheath fits down into the bracket cup (there is no spring on the throttle cable end). | ||
+ | |||
+ | ===== Adjusting The Throttle & Idle Cables ===== | ||
Be sure both cable adjusters are fully minimized. Set the front wheel straight ahead. Turn the throttle grip to fully open (WOT) and hold it there (using the throttle lock star wheel - or a helper). Turn the adjuster on the throttle cable, extending the outer sheath so that the throttle cam (pulled by the inner cable) is just touching the carb WOT Stop. Lock the adjuster in place and release the throttle lock at the grip. | Be sure both cable adjusters are fully minimized. Set the front wheel straight ahead. Turn the throttle grip to fully open (WOT) and hold it there (using the throttle lock star wheel - or a helper). Turn the adjuster on the throttle cable, extending the outer sheath so that the throttle cam (pulled by the inner cable) is just touching the carb WOT Stop. Lock the adjuster in place and release the throttle lock at the grip. | ||
Line 166: | Line 168: | ||
If, when moving the front wheel from left to right to left, the idle changes or the grip does not spring back into the idle position immediately upon release, readjust the idle cable adjuster to assure proper functioning and check that there is no tight bend or kink in the cable creating friction and preventing smooth operation. | If, when moving the front wheel from left to right to left, the idle changes or the grip does not spring back into the idle position immediately upon release, readjust the idle cable adjuster to assure proper functioning and check that there is no tight bend or kink in the cable creating friction and preventing smooth operation. | ||
- | {{:techtalk:evo:body:throttlecableadjustment.jpg?600|}} | + | {{:techtalk:evo:body:throttlecableadjustment.jpg?800|}} |
\\ | \\ | ||
Line 184: | Line 186: | ||
http://xlforum.net/forums/showthread.php?t=459983 | http://xlforum.net/forums/showthread.php?t=459983 | ||
+ | Cable 'Travel Distance' Too Long\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=2073727 | ||
Barnett - Custom Cables - Illustrations & Guide\\ | Barnett - Custom Cables - Illustrations & Guide\\ |