Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:carb01 [2019/08/04 18:06] hippysmack [88-06] |
techtalk:evo:carb01 [2019/08/04 18:36] hippysmack [Aftermarket Idle Mixture Screw and Mods] |
||
---|---|---|---|
Line 446: | Line 446: | ||
====== Aftermarket Idle Mixture Screw and Mods ====== | ====== Aftermarket Idle Mixture Screw and Mods ====== | ||
+ | |||
+ | The EZ-Just is easy to adjust the idle mixture by hand without a screwdriver. \\ | ||
===== L76-87 ===== | ===== L76-87 ===== | ||
Line 458: | Line 460: | ||
===== 88-06 ===== | ===== 88-06 ===== | ||
- | This replacement needle makes it so much easier to adjust the idle mixture. \\ | + | This replacement needle makes it so much easier to adjust the idle mixture. ((Folkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=183642)) \\ |
However, it is easier to count the turns by hand with this mod. \\ | However, it is easier to count the turns by hand with this mod. \\ | ||
A spigot was added to the face of the knob. \\ | A spigot was added to the face of the knob. \\ | ||
Line 464: | Line 466: | ||
Then the side nearest the air cleaner (right of bike) was marked to index when to stop turning to the right. \\ | Then the side nearest the air cleaner (right of bike) was marked to index when to stop turning to the right. \\ | ||
The needle was then removed, drilled and tapped (10 BA) for the spigot. \\ | The needle was then removed, drilled and tapped (10 BA) for the spigot. \\ | ||
+ | You can also drill hole through the knob from side to side and Superglue a screw in it. ((Hot Rod Sporty of the XLFORUM http://xlforum.net/forums/showthread.php?t=183642)) \\ | ||
| Spigot installed to count the turns. ((photo by Folkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=183642)) | | | Spigot installed to count the turns. ((photo by Folkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=183642)) | | ||
|{{:techtalk:evo:carb:idle_mixture_screw_mod_by_folkie.jpg?direct&300|}}| | |{{:techtalk:evo:carb:idle_mixture_screw_mod_by_folkie.jpg?direct&300|}}| | ||
+ | |||
+ | This was done to extend the factory idle mixture screw. \\ | ||
+ | A piece of 3/16" brass tubing and a knurled nut from the hardware store. \\ | ||
+ | |||
+ | | Factory idle mixture screw extended. ((photos by tchuck of the XLFORUM http://xlforum.net/forums/showthread.php?t=183642)) || | ||
+ | |{{:techtalk:evo:carb:idle_mixture_screw_mod_2_by_tchuck.jpg?direct&300|}}|{{:techtalk:evo:carb:idle_mixture_screw_mod_3_by_tchuck.jpg?direct&300|}}| | ||
+ | |||