Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:carb01 [2019/08/04 18:32] hippysmack [88-06] |
techtalk:evo:carb01 [2019/08/22 16:31] hippysmack [L76-87] |
||
---|---|---|---|
Line 446: | Line 446: | ||
====== Aftermarket Idle Mixture Screw and Mods ====== | ====== Aftermarket Idle Mixture Screw and Mods ====== | ||
- | ===== L76-87 ===== | ||
- | An aftermarket kit (like E-Z-just for L76-87 models ((https://cv-performance.com/ez-just-mixture-screw-81-87-harley-keihin)) ) can be purchased with an extended screw head for hand tuning. \\ It comes with the "packing" in case yours has been damaged or is not functioning properly. \\ But, check your local regulations before changing this out to an aftermarket part. \\ You can also find, buy or barter for used parts. \\ ("Please note: it is a violation of federal law to tamper with or disable any emission or noise control device. That is your PSA for the day"). ((XLForum member - chrishajer)) \\ | + | The EZ-Just is easy to adjust the idle mixture by hand without a screwdriver. \\ |
- | + | But, if you've gone 3 to 3-1/2 turns out, then change to the next biggest slow jet. ((Folkis of the XLFORUM http://xlforum.net/forums/showthread.php?t=183642)) \\ | |
- | | Stock idle mixture screw ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=48)) | Stock mixture screw (top) compared to the \\ E-Z-Just mixture screw (bottom) ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=48)) | | + | |
- | |{{:techtalk:evo:carb:idle_mixture_screw_1_by_sifty.jpg?direct&300|}}|{{:techtalk:evo:carb:idle_mixture_screw_2_by_sifty.jpg?direct&300|}}| | + | |
- | + | ||
- | |The aftermarket thumb screw head doesn't a slot for a screwdriver (which also serves as a visual for position). \\ A small hole drilled off center will give a visual position of the screw for adjustment later. ((photos by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=48))||| | + | |
- | |{{:techtalk:evo:carb:idle_mixture_screw_3_by_sifty.jpg?direct&300|}}|{{:techtalk:evo:carb:idle_mixture_screw_4_by_sifty.jpg?direct&300|}}|{{:techtalk:evo:carb:idle_mixture_screw_5_by_sifty.jpg?direct&300|}}| | + | |
===== 88-06 ===== | ===== 88-06 ===== |