Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:carb01a [2020/05/08 06:53] hippysmack [Vacuum slide] |
techtalk:evo:carb01a [2020/05/10 03:54] hippysmack [Float] |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| ==== Float ==== | ==== Float ==== | ||
| + | |||
| + | As a 1994 model year running change, HD changed the configuration of the float pin pedestal. ((HD TSB #M-1035 dated 10-8-1993)) \\ | ||
| + | One of the pedestals now has an interference fit to hold the float pin more securely in place. \\ | ||
| + | A cast-in arrow points at the pedestal that has the interference fit and consequently the direction of pin removal. \\ | ||
| + | The rounded pedestal has the interference fit. The pin is still a uniform width throughout its entire length, so | ||
| + | it can be installed starting from either end. \\ | ||
| + | It should be tapped out from the rounded top pedestal toward the square top pedestal with a small punch or even better, a spring loaded center punch. \\ | ||
| + | Install the pin in the same fashion just in reverse (from the loose side toward the rounded pedestal). \\ | ||
| {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
