Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:evo:carb01a [2020/05/10 03:54] hippysmack [Float] |
techtalk:evo:carb01a [2020/05/10 04:37] hippysmack [Float] |
||
---|---|---|---|
Line 23: | Line 23: | ||
It should be tapped out from the rounded top pedestal toward the square top pedestal with a small punch or even better, a spring loaded center punch. \\ | It should be tapped out from the rounded top pedestal toward the square top pedestal with a small punch or even better, a spring loaded center punch. \\ | ||
Install the pin in the same fashion just in reverse (from the loose side toward the rounded pedestal). \\ | Install the pin in the same fashion just in reverse (from the loose side toward the rounded pedestal). \\ | ||
+ | When removing or installing the float pin, be careful not to break the pedestal(s). \\ | ||
+ | If the pedestal(s) is broken, the carburetor will have to be replaced. \\ | ||
+ | |||
+ | Float pin (27575-88) will not fit the new carburetor. A new float pin (27575-88A) will fit all H-D CV carburetors. \\ | ||
+ | This new part will supersede the current part. \\ | ||
{{:techtalk:evo:carb:removing_keihin_cv_float_bowl_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:carb:removing_keihin_cv_float_bowl_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |