Differences

This shows you the differences between two versions of the page.

--- techtalk:evo:carb02 [2020/08/25 08:00]
ixl2relax [Setting The Float Level]
+++ techtalk:evo:carb02 [2020/08/30 02:37]
ixl2relax [Internal Carb Checks]
@@ Line 207: / Line 207: @@
     * Be sure to reinstall pump rod correctly
   * Be sure you have removed each part, cleaned the ports & reinstalled correctly
-  * Set the Idle Set Screw (located on the right side of the carb, near the throttle cables)\\ so that the Throttle Plate is between the Idle Port (one hole in the carb throat) and the\\ Transfer Ports (which consists of 5 holes nearby)
+  * Set the Idle Set Screw (located on the right side of the carb, near the throttle cables)\\ so that the Throttle Plate is closed as much as possible. Try getting it between the Idle Port\\ (one hole in the carb throat) and the Transfer Ports (which consists of 5 holes nearby).\\ Don't obssess over it if you can't.
 \\
@@ Line 216: / Line 216: @@
 (Using a 1/2-inch spacer to lift the float side of the carb will approximate the 15°-20° angle needed.)\\
 {{:techtalk:evo:carb:hd-cv40-floatlevel-instructions.jpg?250|}}{{:techtalk:evo:carb:hd-cv40-floatlevel.jpg|}}\\
-**Click on the small image above for the detailed instructions regarding setting the float level:**
+**Click on the small image above for the detailed**\\
+**instructions regarding setting the float level:**
 {{:techtalk:evo:carb:cv40-floatvalve-02.jpg?300|}}{{:techtalk:evo:carb:cv40-floatvalve-01.jpg?400|}}

Trace: