Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:carb02 [2020/08/25 08:03] ixl2relax [Setting The Float Level] |
techtalk:evo:carb02 [2020/08/30 02:37] ixl2relax [Internal Carb Checks] |
||
|---|---|---|---|
| Line 207: | Line 207: | ||
| * Be sure to reinstall pump rod correctly | * Be sure to reinstall pump rod correctly | ||
| * Be sure you have removed each part, cleaned the ports & reinstalled correctly | * Be sure you have removed each part, cleaned the ports & reinstalled correctly | ||
| - | * Set the Idle Set Screw (located on the right side of the carb, near the throttle cables)\\ so that the Throttle Plate is between the Idle Port (one hole in the carb throat) and the\\ Transfer Ports (which consists of 5 holes nearby) | + | * Set the Idle Set Screw (located on the right side of the carb, near the throttle cables)\\ so that the Throttle Plate is closed as much as possible. Try getting it between the Idle Port\\ (one hole in the carb throat) and the Transfer Ports (which consists of 5 holes nearby).\\ Don't obssess over it if you can't. |
| \\ | \\ | ||
