Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:carb02 [2019/11/10 03:36] ixl2relax [Enrichener Function (Choke)] |
techtalk:evo:carb02 [2019/11/10 03:38] ixl2relax [Enrichener Function (Choke)] |
||
|---|---|---|---|
| Line 527: | Line 527: | ||
| * Put an adj wrench on the flat part of the cable mounting sleeve. | * Put an adj wrench on the flat part of the cable mounting sleeve. | ||
| * Carefully turn the knurled nut to loosen or tighten the tension until the knob stays pulled out on its own yet freely can be pushed back in with reasonable pressure. | * Carefully turn the knurled nut to loosen or tighten the tension until the knob stays pulled out on its own yet freely can be pushed back in with reasonable pressure. | ||
| - | * Remount the cable & tighten the hex nut. | + | * Remount the cable with the lock washer behind the bracket & tighten the metal hex nut carefully (not over-tightening). |
| - | Check that the knob moves freely in and out after mounting. Do not overtighten the hex mounting nut. | + | Check that the knob moves freely in and out after mounting. |
| The fuel for the enrichener circuit is drawn thru a fixed jet in the float bowl. The air for the enrichener circuit is taken in thru the banana shaped inlet at the top of the carb face (see the face pic above). Sometimes when the enrichener cable is moved, or the carb has been taken off the manifold, the valve piston does not properly seat into its cavity on the carb. If that happens, additional attention must be given to properly reseating the enrichener valve piston. | The fuel for the enrichener circuit is drawn thru a fixed jet in the float bowl. The air for the enrichener circuit is taken in thru the banana shaped inlet at the top of the carb face (see the face pic above). Sometimes when the enrichener cable is moved, or the carb has been taken off the manifold, the valve piston does not properly seat into its cavity on the carb. If that happens, additional attention must be given to properly reseating the enrichener valve piston. | ||
