Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:evo:carb03a [2019/04/09 20:27] hippysmack [Installing the Intake] |
techtalk:evo:carb03a [2019/04/09 20:38] hippysmack [Installing the Intake] |
||
---|---|---|---|
Line 80: | Line 80: | ||
|If you remove the top left motor mount, you'll have \\ easier access to the intake bolts. ((photo by Hippysmack))|Then you can get both hands in there to install \\ the wrench with several pulling options on the bolts. ((photo by Hippysmack))| | |If you remove the top left motor mount, you'll have \\ easier access to the intake bolts. ((photo by Hippysmack))|Then you can get both hands in there to install \\ the wrench with several pulling options on the bolts. ((photo by Hippysmack))| | ||
|{{:techtalk:evo:carb:intake_manifold_14_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:carb:intake_manifold_12_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:evo:carb:intake_manifold_14_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:carb:intake_manifold_12_by_hippysmack.jpg?direct&300|}}| | ||
+ | |||
+ | Do not over-torque the intake bolts. This will probably cause a leak. \\ | ||
+ | |||
+ | | Example of seals with over-torqued bolts. ((photos by Matt Black of the XLFORUM http://xlforum.net/forums/showthread.php?t=2068828&highlight=intake+manifold&page=8)) ||| | ||
+ | |{{:techtalk:evo:carb:intake_bolts_too_tight_1_by_matt_black.jpg?direct&200|}}|{{:techtalk:evo:carb:intake_bolts_too_tight_2_by_matt_black.jpg?direct&200|}}|{{:techtalk:evo:carb:intake_bolts_too_tight_3_by_matt_black.jpg?direct&200|}}| | ||
+ | |||
\\ | \\ |