Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:carb03a [2019/04/09 20:27] hippysmack [Installing the Intake] |
techtalk:evo:carb03a [2019/04/10 00:22] hippysmack [Installing the Intake] |
||
|---|---|---|---|
| Line 64: | Line 64: | ||
| * Install the carb in the intake, the air cleaner on the carb and install the carb support on the heads loosely. | * Install the carb in the intake, the air cleaner on the carb and install the carb support on the heads loosely. | ||
| * Then wiggle the intake up/down and visually inspect the seal top to bottom for evenness. | * Then wiggle the intake up/down and visually inspect the seal top to bottom for evenness. | ||
| - | * Torque the crab support bolts. | + | * Torque the carb support bolts. |
| * Then torque the intake bolts. | * Then torque the intake bolts. | ||
| * Recheck the seal for evenness. | * Recheck the seal for evenness. | ||
| Line 80: | Line 80: | ||
| |If you remove the top left motor mount, you'll have \\ easier access to the intake bolts. ((photo by Hippysmack))|Then you can get both hands in there to install \\ the wrench with several pulling options on the bolts. ((photo by Hippysmack))| | |If you remove the top left motor mount, you'll have \\ easier access to the intake bolts. ((photo by Hippysmack))|Then you can get both hands in there to install \\ the wrench with several pulling options on the bolts. ((photo by Hippysmack))| | ||
| |{{:techtalk:evo:carb:intake_manifold_14_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:carb:intake_manifold_12_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:evo:carb:intake_manifold_14_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:carb:intake_manifold_12_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | Do not over-torque the intake bolts. This will probably cause a leak. \\ | ||
| + | |||
| + | | Example of seals with over-torqued bolts. ((photos by Matt Black of the XLFORUM http://xlforum.net/forums/showthread.php?t=2068828&highlight=intake+manifold&page=8)) ||| | ||
| + | |{{:techtalk:evo:carb:intake_bolts_too_tight_1_by_matt_black.jpg?direct&200|}}|{{:techtalk:evo:carb:intake_bolts_too_tight_2_by_matt_black.jpg?direct&200|}}|{{:techtalk:evo:carb:intake_bolts_too_tight_3_by_matt_black.jpg?direct&200|}}| | ||
| + | |||
| \\ | \\ | ||
