Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:carb03a [2019/04/09 20:38] hippysmack [Installing the Intake] |
techtalk:evo:carb03a [2019/04/10 00:22] hippysmack [Installing the Intake] |
||
|---|---|---|---|
| Line 64: | Line 64: | ||
| * Install the carb in the intake, the air cleaner on the carb and install the carb support on the heads loosely. | * Install the carb in the intake, the air cleaner on the carb and install the carb support on the heads loosely. | ||
| * Then wiggle the intake up/down and visually inspect the seal top to bottom for evenness. | * Then wiggle the intake up/down and visually inspect the seal top to bottom for evenness. | ||
| - | * Torque the crab support bolts. | + | * Torque the carb support bolts. |
| * Then torque the intake bolts. | * Then torque the intake bolts. | ||
| * Recheck the seal for evenness. | * Recheck the seal for evenness. | ||
