Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:elec01 [2019/06/17 18:35] ixl2relax [Grounding is Critical] |
techtalk:evo:elec01 [2019/09/23 08:16] ixl2relax [Battery Charge Level] |
||
|---|---|---|---|
| Line 142: | Line 142: | ||
| Be sure your multimeter BLACK Probe is properly grounded to the Battery Negative Post or to the frame. | Be sure your multimeter BLACK Probe is properly grounded to the Battery Negative Post or to the frame. | ||
| + | Also see additional information on batteries [[techtalk:ref:elec03#batteries|in the REF Section]].\\ | ||
| \\ | \\ | ||
| Line 207: | Line 208: | ||
| In the early models (typically, 1993-earlier), **components were grounded to the frame** at a nearby point while power was distributed throughout the system on a minimal number of wires in the wiring harness. There could be as many as a dozen points on the frame used for grounding. The front lights & instruments were grounded thru a connecting strap between the fork risers & the handlebars. | In the early models (typically, 1993-earlier), **components were grounded to the frame** at a nearby point while power was distributed throughout the system on a minimal number of wires in the wiring harness. There could be as many as a dozen points on the frame used for grounding. The front lights & instruments were grounded thru a connecting strap between the fork risers & the handlebars. | ||
| - | {{:techtalk:evo:elec:86-93-handlebarground.jpg?500|}}{{:techtalk:evo:elec:86-93-devicegrounds.jpg?250|}} | + | {{:techtalk:evo:elec:86-93-handlebarground.jpg?500|}}{{:techtalk:evo:elec:86-93-devicegrounds.jpg?250|}}((http://xlforum.net/forums/showthread.php?t=2073777 - Pics from John Harper - Annotated by IXL2Relax)) |
| **Beginning in 1994**, the wiring harness itself began to carry ground wires to various components. The wiring harness by then consisted of many separate power wires to multiple locations, with a number of circuit breakers protecting the various circuits from overload. | **Beginning in 1994**, the wiring harness itself began to carry ground wires to various components. The wiring harness by then consisted of many separate power wires to multiple locations, with a number of circuit breakers protecting the various circuits from overload. | ||
