Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:evo:elec02 [2019/11/13 03:25]
hippysmack [Sub-Documents]
techtalk:evo:elec02 [2019/12/01 23:18]
ixl2relax [Relays]
Line 197: Line 197:
     * OMRON G8H-UA-007401     * OMRON G8H-UA-007401
   * **NOTE:** The 2007-2009 model years have a significant history of corrosion and gunk collecting in the fuse/relay tray causing low-grade shorts and erratic electrical operation - This is especially problematic if the bike is left outside or operated in the rain. It's a good idea to check & thoroughly clean this tray at least every year (or 4 to 6 months if parked outside).   * **NOTE:** The 2007-2009 model years have a significant history of corrosion and gunk collecting in the fuse/relay tray causing low-grade shorts and erratic electrical operation - This is especially problematic if the bike is left outside or operated in the rain. It's a good idea to check & thoroughly clean this tray at least every year (or 4 to 6 months if parked outside).
 +  * **NOTE2:** In the UK, check for part number Durite 0-727-13.
  
 **(2010-2013)** **(2010-2013)**
Line 285: Line 286:
 {{  :​techtalk:​evo:​elec:​chargingsystem-typical.jpg?​400|}} {{  :​techtalk:​evo:​elec:​chargingsystem-typical.jpg?​400|}}
 Pull the connector between the Stator & Regulator, 2-pin connector near the regulator. Use a multimeter set to the Ohms Scale to measure resistance for these tests. (Before checking resistance, always check that the meter reads '​0'​ ohms when the meter leads are securely pressed together. If the meter reads any value above zero, subtract this value from any resistance readings you take.) Pull the connector between the Stator & Regulator, 2-pin connector near the regulator. Use a multimeter set to the Ohms Scale to measure resistance for these tests. (Before checking resistance, always check that the meter reads '​0'​ ohms when the meter leads are securely pressed together. If the meter reads any value above zero, subtract this value from any resistance readings you take.)
- 
-{{:​techtalk:​ref:​tools:​multimeter_on_ohms_scale.jpg?​direct&​300|}} ((photo by Hippysmack)) \\ 
  
 1) Measure Resistance between the two Stator Pins (should be 0.2 - 0.4 Ohms)\\ 1) Measure Resistance between the two Stator Pins (should be 0.2 - 0.4 Ohms)\\
 2) Measure Resistance from each Stator Pin to Ground (should be infinite Ohms) 2) Measure Resistance from each Stator Pin to Ground (should be infinite Ohms)
- 
-{{:​techtalk:​evo:​elec:​testing_stator_pic_1_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) {{:​techtalk:​evo:​elec:​testing_stator_pic_2_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) {{:​techtalk:​evo:​elec:​testing_stator_pic_3_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) \\ 
  
 **Checking for Sufficient Voltage Production** **Checking for Sufficient Voltage Production**
Line 299: Line 296:
 (Set your multimeter on AC Volts - 100v Scale) (Set your multimeter on AC Volts - 100v Scale)
  
-3) Measure AC Volts produced between the two Stator Pins (see the chart above for the expected voltages) ((Illustration created by IXL2Relax at the XLForum)) {{:​techtalk:​evo:​elec:​testing_stator_pic_4_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) +3) Measure AC Volts produced between the two Stator Pins (see the chart above for the expected voltages) ((Illustration created by IXL2Relax at the XLForum))
  
 Shut down the engine - Reconnect the Regulator - (Be sure to do voltage & ground checks - [[techtalk:​evo:​elec01#​battery_cables_-_the_place_to_start|Click Here]]) Shut down the engine - Reconnect the Regulator - (Be sure to do voltage & ground checks - [[techtalk:​evo:​elec01#​battery_cables_-_the_place_to_start|Click Here]])
 +
 +Example of testing a BAD Stator:​((photos by Hippysmack))\\
 +{{:​techtalk:​ref:​tools:​multimeter_on_ohms_scale.jpg?​direct&​300|}} ​
 +{{:​techtalk:​evo:​elec:​testing_stator_pic_1_by_hippysmack.jpg?​direct&​300|}}{{:​techtalk:​evo:​elec:​testing_stator_pic_2_by_hippysmack.jpg?​direct&​300|}}\\ {{:​techtalk:​evo:​elec:​testing_stator_pic_3_by_hippysmack.jpg?​direct&​300|}}
 +{{:​techtalk:​evo:​elec:​testing_stator_pic_4_by_hippysmack.jpg?​direct&​300|}}\\ ​