Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:engctl01a [2018/06/30 16:49] hippysmack [Using the Timing Mark on the Flywheel] |
techtalk:evo:engctl01a [2018/07/02 05:25] hippysmack removed |
||
|---|---|---|---|
| Line 38: | Line 38: | ||
| * Bump the engine over until the TDC mark is in the window and back it off 1/4-1/2 turn. Then rotate the wheel forward with the mark going past the window with your finger over the spark plug hole. | * Bump the engine over until the TDC mark is in the window and back it off 1/4-1/2 turn. Then rotate the wheel forward with the mark going past the window with your finger over the spark plug hole. | ||
| - | * Once you start to feel pressure on your finger, your close. Press as hard as you want on the hole, the pressure will be stronger than you when your on compression stroke. You may need to roll the engine over several times until your sure of which TDC your at. | + | * Once you start to feel pressure on your finger, your close. Press as hard as you want on the hole, the pressure will be stronger than you when your on compression stroke. ((Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?t=2069380&highlight=tdc&page=2)) You may need to roll the engine over several times until your sure of which TDC your at. |
| | Using the "finger method" to feel compression ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1175659&highlight=tapping+threads&page=3)) | | | Using the "finger method" to feel compression ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1175659&highlight=tapping+threads&page=3)) | | ||
