Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engctl03 [2019/08/29 23:17] ixl2relax [Jiffy Stand Switch (HDI only)] |
techtalk:evo:engctl03 [2019/09/27 07:22] ixl2relax [CKP - Crankshaft Position] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Electronic Fuel Injection System (EFI) ===== | ===== Electronic Fuel Injection System (EFI) ===== | ||
+ | ==== Sub Documents ==== | ||
+ | * [[techtalk:evo:engctl03a|Cleaning Fuel Injectors]] | ||
The Electronic Fuel Injection (EFI) system was introduced on the Sportster models in 2007. It was modified and upgraded in 2014. | The Electronic Fuel Injection (EFI) system was introduced on the Sportster models in 2007. It was modified and upgraded in 2014. | ||
Line 154: | Line 156: | ||
See this [[http://xlforum.net/forums/showthread.php?t=1928519|__XLForum Thread__]]. | See this [[http://xlforum.net/forums/showthread.php?t=1928519|__XLForum Thread__]]. | ||
- | **NOTE:** The CKP P/N for 2004-2005 models is currently 32804-04B (long cable). The CKP P/N for 2006-2017+ models is currently 32707-01C (short cable), which is also used on some BT models. | + | **NOTE1:** The CKP P/N for 2004-2005 models is currently 32804-04B (long cable). The CKP P/N for 2006-2017+ models is currently 32707-01C (short cable), which is also used on some BT models. |
- | With the CKP DTCs being a recurring issue, it would be a good idea to open & clean the CKP to main harness connector located beneath the frame. Put dielectric grease in the connector to help keep out grit & grime, then reconnect it. It may be getting excessive contamination due to its location.((thanks sportsterpaul - http://xlforum.net/forums/showpost.php?p=5603008&postcount=128)) | + | **NOTE2:** With the CKP DTCs being a recurring issue, it would be a good idea to open & clean the CKP to main harness connector located beneath the frame. Put dielectric grease in the connector to help keep out grit & grime, then reconnect it. It may be getting excessive contamination due to its location.((thanks sportsterpaul - http://xlforum.net/forums/showpost.php?p=5603008&postcount=128)) |
\\ | \\ |