Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engctl03 [2019/03/05 19:23] ixl2relax [Jiffy Stand Switch (HDI only)] |
techtalk:evo:engctl03 [2019/03/05 19:44] ixl2relax [Clutch Switch] |
||
---|---|---|---|
Line 9: | Line 9: | ||
* CKP - Crankshaft Position (CKP) Sensor | * CKP - Crankshaft Position (CKP) Sensor | ||
* TMAP - Combined Intake Air Temperature (IAT) & Manifold Absolute Pressure (MAP) Sensor | * TMAP - Combined Intake Air Temperature (IAT) & Manifold Absolute Pressure (MAP) Sensor | ||
- | * ETS - Engine Temperature Sensor | ||
* TPS - Throttle Position Sensor | * TPS - Throttle Position Sensor | ||
- | * O2S - Oxygen Sensors | ||
* IAC - Idle Air Control | * IAC - Idle Air Control | ||
+ | * ETS - Engine Temperature Sensor | ||
+ | * O2S - Oxygen Sensors | ||
* VSS - Vehicle Speed Sensor | * VSS - Vehicle Speed Sensor | ||
* TSM/TSSM - Turn Signal (Security) Module w/internal Bank Angle Sensor (BAS) | * TSM/TSSM - Turn Signal (Security) Module w/internal Bank Angle Sensor (BAS) | ||
Line 454: | Line 454: | ||
==== Clutch Switch ==== | ==== Clutch Switch ==== | ||
+ | |||
+ | Starting in 2007, the Clutch Lever had a switch implemented to allow it to be monitored. | ||
+ | |||
+ | The Clutch Switch and the Neutral Indicator Switch are monitored to assess whether to allow the starter relay to function. If the clutch lever is released & the transmission is not in neutral, the TSM/TSSM/HFSM (2007-2013) or the BCM (2014-later) will not provide the necessary ground for the relay coil to activate (even though the power is being supplied by the starter button/switch). | ||
+ | |||
+ | This is to prevent the bike from lurching forward when attempting to start it. | ||