Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:evo:engctl03 [2019/03/05 19:44]
ixl2relax [Clutch Switch]
techtalk:evo:engctl03 [2019/08/13 16:00]
ixl2relax [Oil Pressure Switch]
Line 434: Line 434:
 ==== Oil Pressure Switch ==== ==== Oil Pressure Switch ====
  
-The Oil Pressure Switch is located at the Oil Filter mount. It is a pressure-actuated diaphragm-type switch that indicates a lack of oil pressure. The switch grounds the sensor wire when there is insufficient oil pressure to open the switch and causes the oil light to illuminate on the indicator bar or the speedometer.+{{ :​techtalk:​evo:​engctl:​oil-pressure-switch-hippysmack.jpg?​200|}}The Oil Pressure Switch is located at the Oil Filter mount. It is a pressure-actuated diaphragm-type switch that indicates a lack of oil pressure. The switch grounds the sensor wire when there is insufficient oil pressure to open the switch and causes the oil light to illuminate on the indicator bar or the speedometer.
  
 If the idle speed should fall below 1000rpms, the light may activate as a warning. If the idle speed should fall below 1000rpms, the light may activate as a warning.
Line 497: Line 497:
  
 After turning ignition OFF, you must wait 10 seconds before turning the ignition back ON to get the fuel pump to reprime. This time out period is necessary for the fuel pump and IAC to reset. After turning ignition OFF, you must wait 10 seconds before turning the ignition back ON to get the fuel pump to reprime. This time out period is necessary for the fuel pump and IAC to reset.
 +
 +
 +{{:​techtalk:​evo:​engctl:​xr1200x_fuel_pump_by_davo_137.jpg?​direct&​300|}} ((photo by Davo_137 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=2072270))
  
 \\ \\