Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:engctl03 [2020/01/03 10:58] ixl2relax [Low Fuel Sensor] |
techtalk:evo:engctl03 [2020/01/03 11:03] ixl2relax [Low Fuel Sensor] |
||
|---|---|---|---|
| Line 522: | Line 522: | ||
| The amount of fuel remaining (2013 models) when the Low Fuel Light activates will vary by model:\\ | The amount of fuel remaining (2013 models) when the Low Fuel Light activates will vary by model:\\ | ||
| - | **{{:common:space100x5px.jpg|}}.65 gallons remaining for XL1200X & XL1200V\\ | + | **{{:common:space100x5px.jpg|}}.65 gallons remaining for XL1200X & XL1200V (w/ 2.1 gal tank)\\ |
| - | {{:common:space100x5px.jpg|}}.80 gallons remaining for XL883R & XL883N\\ | + | {{:common:space100x5px.jpg|}}.80 gallons remaining for XL883R & XL883N (w/ 3.3 gal tank)\\ |
| - | {{:common:space100x5px.jpg|}}1.0 gallons remaining for XL883L & XL1200C/CP/CA/CB\\** | + | {{:common:space100x5px.jpg|}}1.0 gallons remaining for XL883L & XL1200C/CP/CA/CB (w/ 4.5 gal tank)\\** |
| The following illustration is a functional schematic of this sensor/indicator operation. | The following illustration is a functional schematic of this sensor/indicator operation. | ||
| Line 534: | Line 534: | ||
| **NOTE-1** Additional fuel pump info is at this XLForum Thread: http://xlforum.net/forums/showthread.php?t=984808\\ | **NOTE-1** Additional fuel pump info is at this XLForum Thread: http://xlforum.net/forums/showthread.php?t=984808\\ | ||
| - | **NOTE-2** If there is too low voltage (below minimum set point) on the sensor line for more than 15 seconds a DTC B1004 will be | + | **NOTE-2** If there is too low voltage (below minimum set point) on the low fuel signal line for more than 15 seconds a DTC B1004 will be |
| set and the low fuel warning lamp will illuminate. | set and the low fuel warning lamp will illuminate. | ||
| - | **NOTE-3** If there is too high voltage (above maximum set point) on the sensor line for more than 15 seconds a DTC B1005 will be | + | **NOTE-3** If there is too high voltage (above maximum set point) on the low fuel signal line for more than 15 seconds a DTC B1005 will be |
| set and the low fuel warning lamp will illuminate. | set and the low fuel warning lamp will illuminate. | ||
