Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:engmech01 [2019/11/27 22:07] hippysmack [#2 Cam Cover Seal (86-03)] |
techtalk:evo:engmech01 [2019/11/27 22:29] hippysmack [Pinion Gear Runout] |
||
|---|---|---|---|
| Line 142: | Line 142: | ||
| {{:techtalk:evo:engmech:removing_the_pinion_gear_by_grind.jpg?direct&300|}} ((photo by ~Grind~' of the XLFORUM http://xlforum.net/forums/showthread.php?t=1448694)) {{:techtalk:evo:engmech:pinion_key_nub_by_aswracing.jpg?direct&250|}} ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1666277)) | {{:techtalk:evo:engmech:removing_the_pinion_gear_by_grind.jpg?direct&300|}} ((photo by ~Grind~' of the XLFORUM http://xlforum.net/forums/showthread.php?t=1448694)) {{:techtalk:evo:engmech:pinion_key_nub_by_aswracing.jpg?direct&250|}} ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1666277)) | ||
| - | ===== Pinion Gear Runout ===== | + | ===== Pinion Shaft Runout ===== |
| |Attach a scrap piece of metal to the outside of the gearcase and position a gauge holder on it so it won't move while turning over the engine. ((photos by anachris of the XLFORUM ))||| | |Attach a scrap piece of metal to the outside of the gearcase and position a gauge holder on it so it won't move while turning over the engine. ((photos by anachris of the XLFORUM ))||| | ||
| |{{:techtalk:ref:tools:checking_pinion_shaft_runout_1_by_anachris.jpg?direct&300|}}|{{:techtalk:ref:tools:checking_pinion_shaft_runout_2_by_anachris.jpg?direct&300|}}|{{:techtalk:ref:tools:checking_pinion_shaft_runout_3_by_anachris.jpg?direct&300|}}| | |{{:techtalk:ref:tools:checking_pinion_shaft_runout_1_by_anachris.jpg?direct&300|}}|{{:techtalk:ref:tools:checking_pinion_shaft_runout_2_by_anachris.jpg?direct&300|}}|{{:techtalk:ref:tools:checking_pinion_shaft_runout_3_by_anachris.jpg?direct&300|}}| | ||
