Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech01 [2020/02/22 23:13] hippysmack [Shifter shaft Seal] |
techtalk:evo:engmech01 [2020/04/07 18:21] hippysmack [Pinion Shaft Runout] |
||
---|---|---|---|
Line 32: | Line 32: | ||
* [[techtalk:evo:engmech01k|Removing 91-03 Primary Cover]] | * [[techtalk:evo:engmech01k|Removing 91-03 Primary Cover]] | ||
- | ==== Shifter shaft Seal ==== | + | ===== Shifter shaft Seal ===== |
This is a shifter shaft seal on a 1998 1200S primary cover. \\ | This is a shifter shaft seal on a 1998 1200S primary cover. \\ | ||
{{:techtalk:evo:engmech:98_shifter_shaft_seal_1_by_hippysmack.jpg?direct&300|}} \\ | {{:techtalk:evo:engmech:98_shifter_shaft_seal_1_by_hippysmack.jpg?direct&300|}} \\ | ||
Line 160: | Line 160: | ||
|{{:techtalk:ref:tools:checking_pinion_shaft_run-out_1_by_dirtycory.jpg?direct&300|}}|{{:techtalk:ref:tools:checking_pinion_shaft_run-out_2_by_dirtycory.jpg?direct&300|}}| | |{{:techtalk:ref:tools:checking_pinion_shaft_run-out_1_by_dirtycory.jpg?direct&300|}}|{{:techtalk:ref:tools:checking_pinion_shaft_run-out_2_by_dirtycory.jpg?direct&300|}}| | ||
+ | ====== Crankshaft Seal ====== | ||
+ | Here is a trick to hold the spring in place to stop it popping off while you are fitting the seal. ((DEEP DIVER of the XLFORUM http://xlforum.net/forums/showthread.php?p=5489312&highlight=main+seal#post5489312)) \\ | ||
+ | Before fitting it, pack some grease around the spring in the seal groove. You only need a small amount. \\ | ||