Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:engmech01f [2019/11/27 22:16] hippysmack [Installation] |
techtalk:evo:engmech01f [2019/11/27 22:16] hippysmack [Gaskets / Seals] |
||
|---|---|---|---|
| Line 71: | Line 71: | ||
| Before installation, use a straightedge diagonally across the corners to check for warp-age of the cover. \\ | Before installation, use a straightedge diagonally across the corners to check for warp-age of the cover. \\ | ||
| Check the FSM for the 'out of service' spec for warp-age. The thickness of the gasket will compensate for a certain amount of warp-age. \\ | Check the FSM for the 'out of service' spec for warp-age. The thickness of the gasket will compensate for a certain amount of warp-age. \\ | ||
| - | ====== Gaskets / Seals ====== | + | |
