Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech01f [2019/11/27 22:16] hippysmack [Installation] |
techtalk:evo:engmech01f [2019/11/27 22:18] hippysmack [Installation] |
||
---|---|---|---|
Line 71: | Line 71: | ||
Before installation, use a straightedge diagonally across the corners to check for warp-age of the cover. \\ | Before installation, use a straightedge diagonally across the corners to check for warp-age of the cover. \\ | ||
Check the FSM for the 'out of service' spec for warp-age. The thickness of the gasket will compensate for a certain amount of warp-age. \\ | Check the FSM for the 'out of service' spec for warp-age. The thickness of the gasket will compensate for a certain amount of warp-age. \\ | ||
- | ====== Gaskets / Seals ====== | + | |
Line 98: | Line 98: | ||
|Push the cover on carefully by hand. Do not use the \\ screws to pull the cover flush against the case. ((photo by cjburr of the XLFORUM http://xlforum.net/forums/showthread.php?t=49615))|1/4"x20 bolt lengths and torque. ((photo by Hippysmack))| | |Push the cover on carefully by hand. Do not use the \\ screws to pull the cover flush against the case. ((photo by cjburr of the XLFORUM http://xlforum.net/forums/showthread.php?t=49615))|1/4"x20 bolt lengths and torque. ((photo by Hippysmack))| | ||
- | |{{:techtalk:evo:engmech:cam_cover_installation_by_cjburr.jpg?direct&300|}}|{{:techtalk:evo:engmech:98_gearcase_cover_by_hippysmack.jpg?direct&300|}}| | + | |{{:techtalk:evo:engmech:cam_cover_installation_by_cjburr.jpg?direct&300|}}|{{:techtalk:evo:engmech:98_gearcase_cover_by_hippysmack.jpg?direct&400|}}| |
+ | ====== Gaskets / Seals ====== | ||
===== #2 Cam - Cover Seal (86-03) ===== | ===== #2 Cam - Cover Seal (86-03) ===== | ||
Seal number (11124): \\ | Seal number (11124): \\ |