Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:evo:engmech01k [2019/11/12 17:11] hippysmack [Remove the clutch ramp assembly] |
techtalk:evo:engmech01k [2019/11/12 17:25] hippysmack [Loosen the primary chain adjuster] |
||
---|---|---|---|
Line 60: | Line 60: | ||
===== Loosen the primary chain adjuster ===== | ===== Loosen the primary chain adjuster ===== | ||
+ | Hold the stud with a 1/4" Allen wrench and use a 7/8" open end wrench to loosen the tightening nut. \\ | ||
+ | Once the nut is loose, unscrew the stud until it bottoms out to loosen the chain adjuster. \ | ||
+ | This is easier done before removing the cover since the engine holds the assembly in place. \\ | ||
+ | If you don't loosen this before re-installing the cover, it will be more difficult to install the cover later. \\ | ||
+ | {{:techtalk:evo:engmech:removing_primary_cover_5_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:removing_primary_cover_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
===== Loosen and remove the primary cover ===== | ===== Loosen and remove the primary cover ===== | ||