Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:engmech01k [2019/11/12 17:11] hippysmack [Remove the clutch ramp assembly] |
techtalk:evo:engmech01k [2019/11/12 17:28] hippysmack [Loosen and remove the primary cover] |
||
|---|---|---|---|
| Line 60: | Line 60: | ||
| ===== Loosen the primary chain adjuster ===== | ===== Loosen the primary chain adjuster ===== | ||
| + | Hold the stud with a 1/4" Allen wrench and use a 7/8" open end wrench to loosen the tightening nut. \\ | ||
| + | Once the nut is loose, unscrew the stud until it bottoms out to loosen the chain adjuster. \ | ||
| + | This is easier done before removing the cover since the engine holds the assembly in place. \\ | ||
| + | If you don't loosen this before re-installing the cover, it will be more difficult to install the cover later. \\ | ||
| + | {{:techtalk:evo:engmech:removing_primary_cover_5_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:removing_primary_cover_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| ===== Loosen and remove the primary cover ===== | ===== Loosen and remove the primary cover ===== | ||
| Line 70: | Line 75: | ||
| You can punch the holes with a screwdriver, insert the screws for holding and it makes reassembly less of a headache. \\ | You can punch the holes with a screwdriver, insert the screws for holding and it makes reassembly less of a headache. \\ | ||
| - | {{:techtalk:evo:elec:replacing_the_stator_on_91-03_pic_1_by_tigercreek.jpg?direct&300|}} ((photo by tigercreek of the XLFORUM http://xlforum.net/forums/showthread.php?t=1823130)) {{:techtalk:ref:tools:primary_cover_screw_holder_by_cjburr.jpg?direct&300|}} ((photo by cjburr of the XLFORUM http://xlforum.net/forums/showthread.php?t=49915)) \\ | + | {{:techtalk:evo:engmech:removing_primary_cover_8_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:removing_primary_cover_7_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:primary_cover_screw_holder_by_cjburr.jpg?direct&300|}} ((photo by cjburr of the XLFORUM http://xlforum.net/forums/showthread.php?t=49915)) \\ |
| - | + | ||
| - | Loosening the primary chain adjuster takes the pressure off the primary chain from the cover. \\ | + | |
| - | + | ||
| \\ | \\ | ||
