Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:evo:engmech03a [2019/08/01 04:09]
hippysmack [Loose Head Bolt Studs]
techtalk:evo:engmech03a [2019/08/04 14:23]
hippysmack [Using Double Nuts]
Line 59: Line 59:
  
 ==== Using a pipe wrench to loosen the stud ==== ==== Using a pipe wrench to loosen the stud ====
 +
 +A propane torch works well to melt or loosen old Loctite (red or blue) on the threads. \\
  
 Catch the stud down low, but not so low as to run the wrench into the block. \\ Catch the stud down low, but not so low as to run the wrench into the block. \\
Line 72: Line 74:
 The pipe wrench is mainly to break torque. It's easier to get out of hand and damage something if it's not needed after that. \\ The pipe wrench is mainly to break torque. It's easier to get out of hand and damage something if it's not needed after that. \\
  
 +If the pipe wrench slips, you may need to adjust the wrench so the stud is closer to the inside teeth. \\
 +You may need to loosen the jaws to move the stud back. \\
 +The wrench doesn'​t have to be tight against the stud to grip. \\
 +It works by the magic of binding onto the stud. \\
 +It's important to hold center on the wrench and stud with one hand. \\
 +You can try getting a grip by tilting the handle up with just a little pressure and then back level. \\
 +You just have to find a way to make the wrench bind against the stud. \\
 +
 +|If the wrench doesn'​t grip, make it bind on the stud.  ((photo by Blue Scoot of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=2074117&​highlight=head+gasket&​page=6)) ​ |
 +|{{:​techtalk:​evo:​engmech:​removing_cylinder_stud_with_pipe_wrench_by_blue_scoot.jpg?​direct&​300|}}|
 +
 +==== Using Double Nuts / Jam Nuts ====
 +
 +
 +|  Three jam nuts used here. ((photo by A 4 liter V8 eater of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​p=4442041#​post4442041))|
 +|{{:​techtalk:​evo:​engmech:​tightening_cylinder_-_head_studs_by_a_4_liter_v8_eater.png?​direct&​300|}}|
 ===== Stripped Case Threads ===== ===== Stripped Case Threads =====