Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech03a [2019/08/04 14:11] hippysmack [Using a pipe wrench to loosen the stud] |
techtalk:evo:engmech03a [2019/08/04 14:23] hippysmack [Using Double Nuts] |
||
---|---|---|---|
Line 84: | Line 84: | ||
|If the wrench doesn't grip, make it bind on the stud. ((photo by Blue Scoot of the XLFORUM http://xlforum.net/forums/showthread.php?t=2074117&highlight=head+gasket&page=6)) | | |If the wrench doesn't grip, make it bind on the stud. ((photo by Blue Scoot of the XLFORUM http://xlforum.net/forums/showthread.php?t=2074117&highlight=head+gasket&page=6)) | | ||
|{{:techtalk:evo:engmech:removing_cylinder_stud_with_pipe_wrench_by_blue_scoot.jpg?direct&300|}}| | |{{:techtalk:evo:engmech:removing_cylinder_stud_with_pipe_wrench_by_blue_scoot.jpg?direct&300|}}| | ||
+ | |||
+ | ==== Using Double Nuts / Jam Nuts ==== | ||
+ | |||
+ | |||
+ | | Three jam nuts used here. ((photo by A 4 liter V8 eater of the XLFORUM http://xlforum.net/forums/showthread.php?p=4442041#post4442041))| | ||
+ | |{{:techtalk:evo:engmech:tightening_cylinder_-_head_studs_by_a_4_liter_v8_eater.png?direct&300|}}| | ||
===== Stripped Case Threads ===== | ===== Stripped Case Threads ===== | ||