Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech03a [2019/08/04 14:18] hippysmack [Using a pipe wrench to loosen the stud] |
techtalk:evo:engmech03a [2019/08/04 14:32] hippysmack [Using Double Nuts / Jam Nuts] |
||
---|---|---|---|
Line 85: | Line 85: | ||
|{{:techtalk:evo:engmech:removing_cylinder_stud_with_pipe_wrench_by_blue_scoot.jpg?direct&300|}}| | |{{:techtalk:evo:engmech:removing_cylinder_stud_with_pipe_wrench_by_blue_scoot.jpg?direct&300|}}| | ||
- | ==== Using Double Nuts ==== | + | ==== Using Double Nuts / Jam Nuts ==== |
+ | Install 2 nuts on the top threads and torque the two nuts to 35ft pounds or higher. \\ | ||
+ | Be aware the tall studs can stretch if it takes too much torque to break them free. \\ | ||
+ | Be sure to use rags around the bore so as to not get any debris in the engine while removing the stud(s). \\ | ||
+ | | Three jam nuts used here. ((photo by A 4 liter V8 eater of the XLFORUM http://xlforum.net/forums/showthread.php?p=4442041#post4442041))| | ||
+ | |{{:techtalk:evo:engmech:tightening_cylinder_-_head_studs_by_a_4_liter_v8_eater.png?direct&300|}}| | ||
===== Stripped Case Threads ===== | ===== Stripped Case Threads ===== | ||