Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:engmech03a [2019/08/04 14:48] hippysmack [Sub Documents] |
techtalk:evo:engmech03a [2019/12/10 02:32] hippysmack |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| With the bolts loosening, it is at least suspect that the threads or the hole strength is compromised. ((Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?t=2074117&page=2)) \\ | With the bolts loosening, it is at least suspect that the threads or the hole strength is compromised. ((Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?t=2074117&page=2)) \\ | ||
| - | | Weakest head stud holes in the case. ((photo by Hippysmack)) | | + | | Weakest head stud holes in the case. ((photo by Hippysmack)) | Head bolt pulled out of the case. ((photo by Blue Scoot of the XLFORUM http://xlforum.net/forums/showthread.php?p=5793625)) | |
| - | |{{:techtalk:evo:engmech:weakest_cylinder_bolt_threads_by_hippysmack.jpg?direct&300|}}| | + | |{{:techtalk:evo:engmech:weakest_cylinder_bolt_threads_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:engmech:head_bolt_pulled_out_by_blue_scoot.jpg?direct&300|}}| |
| There is a procedure in the manual for tightening the studs before installing the cylinders and heads. \\ | There is a procedure in the manual for tightening the studs before installing the cylinders and heads. \\ | ||
