Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech03a [2019/12/10 02:32] hippysmack |
techtalk:evo:engmech03a [2020/04/28 22:53] hippysmack ↷ Links adapted because of a move operation |
||
---|---|---|---|
Line 6: | Line 6: | ||
See also in the Sportsterpedia: | See also in the Sportsterpedia: | ||
* [[techtalk:evo:engmech03b|Time-Sert Repair on Engine Case Cylinder / Head Stud Hole]] | * [[techtalk:evo:engmech03b|Time-Sert Repair on Engine Case Cylinder / Head Stud Hole]] | ||
- | * [[techtalk:ref:genmsr36#warped_or_damaged_thread_repair|Warped or Damaged Thread Repair]] | + | * [[techtalk:ref:tools023#warped_or_damaged_thread_repair|Warped or Damaged Thread Repair]] |
===== Loose Head Bolt Studs ===== | ===== Loose Head Bolt Studs ===== | ||
A big concern about the studs becoming loose is the threads being stripped in the case. \\ | A big concern about the studs becoming loose is the threads being stripped in the case. \\ | ||
Line 92: | Line 92: | ||
| Three jam nuts used here. ((photo by A 4 liter V8 eater of the XLFORUM http://xlforum.net/forums/showthread.php?p=4442041#post4442041))| | | Three jam nuts used here. ((photo by A 4 liter V8 eater of the XLFORUM http://xlforum.net/forums/showthread.php?p=4442041#post4442041))| | ||
|{{:techtalk:evo:engmech:tightening_cylinder_-_head_studs_by_a_4_liter_v8_eater.png?direct&300|}}| | |{{:techtalk:evo:engmech:tightening_cylinder_-_head_studs_by_a_4_liter_v8_eater.png?direct&300|}}| | ||
+ | ===== Cleaning the Case Threads ===== | ||
+ | |||
+ | The threads on the head studs as well as in the case need to be clean and free of rust / debris and they need to be straight in order to obtain proper torque on the heads. \\ | ||
+ | |||
+ | The photos below are of before (L) and after (R) chasing the case threads with a 3/8"x16 tap. \\ | ||
+ | The dirty threads will add preload to the torque readings and can easily give false readings on the wrench which could affect head gasket performance. \\ | ||
+ | |||
+ | {{:techtalk:evo:engmech:head_bolt_threads_before_chasing_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:head_bolt_threads_chased_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
+ | |||
===== Stripped Case Threads ===== | ===== Stripped Case Threads ===== | ||