Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech04c [2019/10/08 13:25] hippysmack |
techtalk:evo:engmech04c [2019/11/03 04:21] hippysmack [Compatibility] |
||
---|---|---|---|
Line 18: | Line 18: | ||
So due to functionality, the 86-90 mid section won't fit 91-03 boxes. \\ | So due to functionality, the 86-90 mid section won't fit 91-03 boxes. \\ | ||
But the 91-03 middle cover will fit 86-90 boxes. \\ | But the 91-03 middle cover will fit 86-90 boxes. \\ | ||
+ | |||
+ | ===== Gaskets ===== | ||
+ | |||
+ | Clean the mating surfaces of all oil / trash before setting the gaskets in place. \\ | ||
+ | With the bolts 'lightly' hand seated, check all around the box for a gasket squirting out the side before tightening the bolts. \\ | ||
+ | It's easy to 'just nudge' the top section and squeeze a portion of the rubber gasket out while positioning it. \\ | ||
+ | |||
+ | {{:techtalk:evo:engmech:pinched_rocker_box_gasket_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
===== Bolt Installation Sequence ===== | ===== Bolt Installation Sequence ===== | ||
Line 70: | Line 78: | ||
Aftermarket pushrods can be purchased in longer or shorter lengths than stock ones to get the measurement within .100". | Aftermarket pushrods can be purchased in longer or shorter lengths than stock ones to get the measurement within .100". | ||
- | {{:techtalk:evo:engmech:lifter_preload_by_aswracing.jpg?direct&300|}} ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=322680&page=5)) \\ | + | {{:techtalk:evo:engmech:lifter_preload_by_aswracing.jpg?direct&200|}} ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=322680&page=5)) \\ |
\\ | \\ |