Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech04c [2019/10/08 13:26] hippysmack [Check Pushrod Length] |
techtalk:evo:engmech04c [2020/09/01 05:33] hippysmack [Gaskets] |
||
---|---|---|---|
Line 19: | Line 19: | ||
But the 91-03 middle cover will fit 86-90 boxes. \\ | But the 91-03 middle cover will fit 86-90 boxes. \\ | ||
+ | ===== Gaskets ===== | ||
+ | |||
+ | Clean the mating surfaces of all oil / trash before setting the gaskets in place. \\ | ||
+ | With the bolts 'lightly' hand seated, check all around the box for a gasket squirting out the side before tightening the bolts. \\ | ||
+ | It's easy to 'just nudge' the top section and squeeze a portion of the rubber gasket out while positioning it. \\ | ||
+ | |||
+ | {{:techtalk:evo:engmech:pinched_rocker_box_gasket_1_by_sep69.jpg?direct&300|}} ((photo by sep69 of the XLFORUM http://xlforum.net/forums/showthread.php?p=3754227)) {{:techtalk:evo:engmech:pinched_rocker_box_gasket_2_by_sep69.jpg?direct&300|}} ((photo by sep69 of the XLFORUM http://xlforum.net/forums/showthread.php?p=3754227)) \\ | ||
===== Bolt Installation Sequence ===== | ===== Bolt Installation Sequence ===== | ||
The FSM details the proper installation sequence of the bolts. \\ | The FSM details the proper installation sequence of the bolts. \\ |