Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
techtalk:evo:engmech07a [2019/11/07 00:04] hippysmack [Making 91-03 Breather Bolt Holes Smaller] |
techtalk:evo:engmech07a [2019/11/07 00:06] hippysmack [Making 91-03 Breather Bolt Holes Smaller] |
||
---|---|---|---|
Line 16: | Line 16: | ||
The holding block was needed to keep the bolt straight while boring a hole through it. \\ | The holding block was needed to keep the bolt straight while boring a hole through it. \\ | ||
- | You could use a block of wood, plastic or steel. The hole was .2720" and tapped 5/16"x24. \\ | + | You could use a block of wood, plastic or steel. The hole was drilled .2720" and tapped 5/16"x24. \\ |
Each bolt was screwed into the hole, corner to corner lines drawn across the head to find center and the center punched to keep the bit from wandering. \\ | Each bolt was screwed into the hole, corner to corner lines drawn across the head to find center and the center punched to keep the bit from wandering. \\ | ||