Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech09 [2019/11/30 16:54] hippysmack [Replacement] |
techtalk:evo:engmech09 [2019/12/17 00:00] hippysmack [Loose / Broken Lock Plate Screws] |
||
---|---|---|---|
Line 155: | Line 155: | ||
The isolators are not holding the screws in. They are just against them (shouldn't be much pressure if any against the screws). \\ | The isolators are not holding the screws in. They are just against them (shouldn't be much pressure if any against the screws). \\ | ||
Most likely, only with severe deflection of that pivot pin would pressure be placed on the plate and shear the bolts. \\ | Most likely, only with severe deflection of that pivot pin would pressure be placed on the plate and shear the bolts. \\ | ||
+ | You can drill the center of the screw with a small drill bit and try and Easy-Out to remove it. \\ | ||
| Loose / broken lock plate screws. ((photo by Nytstr of the XLFORUM http://xlforum.net/forums/showthread.php?t=1313091)) | The screws are hidden from the outside. ((photos by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=1313091&page=2)) || | | Loose / broken lock plate screws. ((photo by Nytstr of the XLFORUM http://xlforum.net/forums/showthread.php?t=1313091)) | The screws are hidden from the outside. ((photos by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=1313091&page=2)) || | ||
|{{:techtalk:evo:susp:rear_engine_mount_by_nytstr.jpg?direct&300|}}| {{:techtalk:evo:susp:07_rear_motor_mount_2_by_cosmo_kramer.jpg?direct&300|}}|{{:techtalk:evo:susp:07_rear_motor_mount_3_by_cosmo_kramer.jpg?direct&300|}}| | |{{:techtalk:evo:susp:rear_engine_mount_by_nytstr.jpg?direct&300|}}| {{:techtalk:evo:susp:07_rear_motor_mount_2_by_cosmo_kramer.jpg?direct&300|}}|{{:techtalk:evo:susp:07_rear_motor_mount_3_by_cosmo_kramer.jpg?direct&300|}}| | ||
+ | |||
+ | {{:techtalk:evo:susp:broken_screw_removal_1_by_luxblue.jpg?direct&300|}} ((photo by LuxBlue of the XLFORUM)) {{:techtalk:evo:susp:broken_screw_removal_2_by_luxblue.jpg?direct&300|}} ((photo by LuxBlue of the XLFORUM)) {{:techtalk:evo:susp:broken_screw_removal_3_by_luxblue.jpg?direct&300|}} ((photo by LuxBlue of the XLFORUM)) | ||
+ | |||
+ | |||
==== Worn / Rusty Pivot Shaft ==== | ==== Worn / Rusty Pivot Shaft ==== | ||
Line 218: | Line 223: | ||
On the shoulder of the shaft there are two "flat" spots 180° from each other. The retainer plate has two small tabs that fit into the flat spots. \\ | On the shoulder of the shaft there are two "flat" spots 180° from each other. The retainer plate has two small tabs that fit into the flat spots. \\ | ||
The shaft can still rotate a small amount until the shoulder on the shaft comes into contact with the tab. \\ | The shaft can still rotate a small amount until the shoulder on the shaft comes into contact with the tab. \\ | ||
- | The backing plate has two tabs that engage those flat spots on the pivot shaft. \\ | + | The backing plate has two tabs that engage those flat spots on the pivot shaft and that connection locks the shaft from rotating once installed. \\ |
{{:techtalk:evo:susp:07_rear_motor_mount_16_by_cosmo_kramer.jpg?direct&300|}} ((photo by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=473423)) {{:techtalk:evo:susp:07_rear_motor_mount_17_by_cosmo_kramer.jpg?direct&300|}} ((photo by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=473423)) {{:techtalk:evo:susp:07_rear_motor_mount_18_by_cosmo_kramer.jpg?direct&200|}} ((photo by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=473423)) \\ | {{:techtalk:evo:susp:07_rear_motor_mount_16_by_cosmo_kramer.jpg?direct&300|}} ((photo by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=473423)) {{:techtalk:evo:susp:07_rear_motor_mount_17_by_cosmo_kramer.jpg?direct&300|}} ((photo by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=473423)) {{:techtalk:evo:susp:07_rear_motor_mount_18_by_cosmo_kramer.jpg?direct&200|}} ((photo by Cosmo Kramer of the XLFORUM http://xlforum.net/forums/showthread.php?t=473423)) \\ |