Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:engmech09e [2021/08/02 03:02] hippysmack [Top Center Mount Bracket] |
techtalk:evo:engmech09e [2021/08/02 20:44] hippysmack [Top Center Mount Bracket] |
||
|---|---|---|---|
| Line 21: | Line 21: | ||
| * Has the slotted hole through both the "ears" that mount to each head for adjustment. | * Has the slotted hole through both the "ears" that mount to each head for adjustment. | ||
| * Has the same minimal welding on the back of the side plates (as in previous) that attach to the base of the mount. | * Has the same minimal welding on the back of the side plates (as in previous) that attach to the base of the mount. | ||
| - | * Can be used on 86-94 models without altercations. | + | * Can be used on 86-94 models without alterations. |
| * 1994 Sportster Top Center Mount: | * 1994 Sportster Top Center Mount: | ||
| * Made for right side petcock. | * Made for right side petcock. | ||
| Line 30: | Line 30: | ||
| * Has the slotted hole through both the "ears" that mount to each head for adjustment. | * Has the slotted hole through both the "ears" that mount to each head for adjustment. | ||
| * Has the same minimal welding on the back of the side plates (as in previous) that attach to the base of the mount. | * Has the same minimal welding on the back of the side plates (as in previous) that attach to the base of the mount. | ||
| - | * Can be used on 86-94 models without altercations. | + | * Can be used on 86-94 models without alterations. |
| * 1995-1996 Sportster Top Center Mount: | * 1995-1996 Sportster Top Center Mount: | ||
| * Made for left side petcock. \\ 95-up gas tanks have the fuel petcock on the left side as opposed to the right on previous models. \\ The middle of the center mount's base was hogged out to accommodate the left side petcock and fuel hoses. | * Made for left side petcock. \\ 95-up gas tanks have the fuel petcock on the left side as opposed to the right on previous models. \\ The middle of the center mount's base was hogged out to accommodate the left side petcock and fuel hoses. | ||
| Line 38: | Line 38: | ||
| * The rear bolt hole for attaching to the heads changed. The front is still slotted but the rear is now a round hole. | * The rear bolt hole for attaching to the heads changed. The front is still slotted but the rear is now a round hole. | ||
| * Has a T-stud welded to the upper right side for a plastic wire clamp. | * Has a T-stud welded to the upper right side for a plastic wire clamp. | ||
| - | * Can be used on 97 models with altercations. | + | * It has a full weld on the inside of the side plates that attach to the base of the mount. |
| + | * Can be used on 97 models without alterations. | ||
| * Can be used on 98-03 models by installing the enrichment cable support bracket (69035-95). \\ (relocate the horn and the enrichment cable can be installed in that slotted hole without the extra support bracket) | * Can be used on 98-03 models by installing the enrichment cable support bracket (69035-95). \\ (relocate the horn and the enrichment cable can be installed in that slotted hole without the extra support bracket) | ||
| * Can be used on 86-94 models if the ignition switch is relocated. | * Can be used on 86-94 models if the ignition switch is relocated. | ||
| * 1997 Sportster Top Center Mount: | * 1997 Sportster Top Center Mount: | ||
| * Made for left side petcock. | * Made for left side petcock. | ||
| - | * The 97 center mount looks identical to the 95-96 mount but the big hole thru the center of the base was cut larger on the left side. | + | * The 97 center mount looks identical to the 95-96 mount but the big hole thru the center of the base was cut different on the left side. \\ The "wings" or side ends at the base plate are also longer giving more strength to the assembly. |
| * Does not support a key switch. | * Does not support a key switch. | ||
| * The left center edge was bent down differently still having a vertical slot in the center (slot faces up, hole faces out). \\ A bolt or threaded rubber bumper bolts thru the slot to mount the horn. | * The left center edge was bent down differently still having a vertical slot in the center (slot faces up, hole faces out). \\ A bolt or threaded rubber bumper bolts thru the slot to mount the horn. | ||
| Line 49: | Line 50: | ||
| * The front bolt hole for attaching to the heads is slotted and the rear hole is round. | * The front bolt hole for attaching to the heads is slotted and the rear hole is round. | ||
| * Has a T-stud welded to the upper right side for a plastic wire clamp. | * Has a T-stud welded to the upper right side for a plastic wire clamp. | ||
| + | * It has a full weld on the inside of the side plates that attach to the base of the mount. | ||
| + | * Can be used on 86-94 models if the ignition switch is relocated. | ||
| + | * Can be used on 95-97 models without alterations. | ||
| + | * Can be used on 98-03 models by installing the enrichment cable support bracket (69035-95). \\ (relocate the horn and the enrichment cable can be installed in that slotted hole without the extra support bracket) | ||
| * 1998-2003 Sportster Top Center Mount: | * 1998-2003 Sportster Top Center Mount: | ||
| * Made for left side petcock. | * Made for left side petcock. | ||
| Line 56: | Line 61: | ||
| * Does not support a key switch. | * Does not support a key switch. | ||
| * Has a 1/4" hole through the back plate to bolt the VOES to the rear side of the mount. | * Has a 1/4" hole through the back plate to bolt the VOES to the rear side of the mount. | ||
| + | * It has a full weld on the inside of the side plates that attach to the base of the mount. | ||
| * The front bolt hole for attaching to the heads is slotted and the rear hole is round. | * The front bolt hole for attaching to the heads is slotted and the rear hole is round. | ||
| * Has a T-stud welded to the upper right side for a plastic wire clamp. | * Has a T-stud welded to the upper right side for a plastic wire clamp. | ||
| + | * Can be used on used on 86-94 models if the ignition switch is relocated. | ||
| + | * Can be used on 95-97 models by deleting the enrichment cable support bracket (69035-95). | ||
| | 1986-1991 883 Sportster Top Center Motor Mount ((photos courtesy of c3cycle.com https://www.c3cycle.com/)) ||| | | 1986-1991 883 Sportster Top Center Motor Mount ((photos courtesy of c3cycle.com https://www.c3cycle.com/)) ||| | ||
| Line 65: | Line 73: | ||
| |{{:techtalk:evo:engmech:motor_mount-top_center_1986-1991_1100-1200_16278-86_pic1_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1986-1991_1100-1200_16278-86_pic2_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1986-1991_1100-1200_16278-86_pic3_by_c3-cycle-tech.jpg?direct&300|}}| | |{{:techtalk:evo:engmech:motor_mount-top_center_1986-1991_1100-1200_16278-86_pic1_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1986-1991_1100-1200_16278-86_pic2_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1986-1991_1100-1200_16278-86_pic3_by_c3-cycle-tech.jpg?direct&300|}}| | ||
| - | | 1992-1993 Sportster Top Center Motor Mount Bracket (16278-86A) ((photos courtesy of Vintage Parts Suppliers, [[https://www.ebay.com/str/vintagepartssuppliers?_trksid=p2047675.l2563|Link to Ebay Store]] )) ||| | + | | 1992-1993 Sportster Top Center Motor Mount Bracket (16278-86A) ((photos courtesy of Ebay seller, Vintage Parts Suppliers, [[https://www.ebay.com/str/vintagepartssuppliers?_trksid=p2047675.l2563|Link to Ebay Store]] )) ||| |
| |{{:techtalk:evo:engmech:motor_mount-top_center_1992-1993_16278-86a_pic1_by_vintagepartssuppliers.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1992-1993_16278-86a_pic2_by_vintagepartssuppliers.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1992-1993_16278-86a_pic3_by_vintagepartssuppliers.jpg?direct&300|}}| | |{{:techtalk:evo:engmech:motor_mount-top_center_1992-1993_16278-86a_pic1_by_vintagepartssuppliers.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1992-1993_16278-86a_pic2_by_vintagepartssuppliers.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1992-1993_16278-86a_pic3_by_vintagepartssuppliers.jpg?direct&300|}}| | ||
| Line 74: | Line 82: | ||
| |{{:techtalk:evo:engmech:motor_mount-top_center_1995-1996_16278-95_pic1_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1995-1996_16278-95_pic2_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1995-1996_16278-95_pic3_by_c3-cycle-tech.jpg?direct&300|}}| | |{{:techtalk:evo:engmech:motor_mount-top_center_1995-1996_16278-95_pic1_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1995-1996_16278-95_pic2_by_c3-cycle-tech.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1995-1996_16278-95_pic3_by_c3-cycle-tech.jpg?direct&300|}}| | ||
| - | | 1998-2003 Sportster Top Center Motor Mount Bracket (16278-95B) ((photos courtesy of Vintage Parts Suppliers, [[https://www.ebay.com/str/vintagepartssuppliers?_trksid=p2047675.l2563|Link to Ebay Store]] )) || | + | | 1997 Sportster Top Center Motor Mount (16278-95A) ((Photos courtesy of Ebay seller, cmachineworks [[https://www.ebay.com/str/cmachineworks?_trksid=p2047675.l2563|Link to Ebay Store]] )) ||| |
| + | |{{:techtalk:evo:engmech:motor_mount-top_center_1997_16278-95a_pic1_by_cmachineworks.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1997_16278-95a_pic2_by_cmachineworks.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1997_16278-95a_pic3_by_cmachineworks.jpg?direct&300|}}| | ||
| + | |||
| + | | 1998-2003 Sportster Top Center Motor Mount Bracket (16278-95B) ((photos courtesy of Ebay seller, Vintage Parts Suppliers, [[https://www.ebay.com/str/vintagepartssuppliers?_trksid=p2047675.l2563|Link to Ebay Store]] )) ||| | ||
| |{{:techtalk:evo:engmech:motor_mount-top_center_1998-2003_16278-95b_pic1_by_vintagepartssuppliers.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1998-2003_16278-95b_pic3_by_vintagepartssuppliers.jpg?direct&300|}}| {{:techtalk:evo:engmech:motor_mount-top_center_1998-2003_16278-95b_pic2_by_vintagepartssuppliers.jpg?direct&300|}}| | |{{:techtalk:evo:engmech:motor_mount-top_center_1998-2003_16278-95b_pic1_by_vintagepartssuppliers.jpg?direct&300|}}|{{:techtalk:evo:engmech:motor_mount-top_center_1998-2003_16278-95b_pic3_by_vintagepartssuppliers.jpg?direct&300|}}| {{:techtalk:evo:engmech:motor_mount-top_center_1998-2003_16278-95b_pic2_by_vintagepartssuppliers.jpg?direct&300|}}| | ||
