Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
techtalk:evo:engmech09n [2021/07/28 02:21] hippysmack [Replacement] |
techtalk:evo:engmech09n [2024/01/04 01:52] hippysmack |
||
---|---|---|---|
Line 9: | Line 9: | ||
In addition, there is a pivot shaft that supports the swing arm bearings / bolts on the outside, and goes through the rear mounting lug on the tranny case. \\ | In addition, there is a pivot shaft that supports the swing arm bearings / bolts on the outside, and goes through the rear mounting lug on the tranny case. \\ | ||
If the pivot shaft is loose in the rear mount lug, it will need to be replaced also. \\ | If the pivot shaft is loose in the rear mount lug, it will need to be replaced also. \\ | ||
- | Lube and properly tightening steering head bearings are also important part of the process. ((XLXR http://xlforum.net/forums/showthread.php?t=1526368&highlight=motor+mounts&page=3)) | + | Lube and properly tightening steering head bearings are also important part of the process. ((XLXR https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/rubber-mount-sportster-motorcycle-talk-2004-2006/140794-check-motor-mounts-and-swing-arm-bearings-asap/page3?t=1526368&highlight=motor+mounts&page=3)) |
You can raise the bike on a jack and see engine swing better when pushed than while sitting on the tires. \\ | You can raise the bike on a jack and see engine swing better when pushed than while sitting on the tires. \\ |