Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:evo:oil03 [2020/06/06 02:27] hippysmack [Oil Pump Drive Gear] |
techtalk:evo:oil03 [2020/11/07 04:46] hippysmack [Oil Pump Pressure] |
||
---|---|---|---|
Line 72: | Line 72: | ||
| Typical 98-up gerotor positioning over the pickup cavities (07 pump shown). ((photos by Hippysmack)) || | | Typical 98-up gerotor positioning over the pickup cavities (07 pump shown). ((photos by Hippysmack)) || | ||
|{{:techtalk:evo:oil:2007_and_up_oil_pump_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:oil:2007_and_up_oil_pump_5a_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:evo:oil:2007_and_up_oil_pump_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:oil:2007_and_up_oil_pump_5a_by_hippysmack.jpg?direct&300|}}| | ||
- | ====== Oil Pump Pressure ====== | + | ====== Oil Pump Pressure (86-Up) ====== |
+ | See also [[techtalk:ref:oil15|Installing an Oil Pressure Gauge]] in the REF section of the Sportsterpedia. \\ | ||
+ | |||
+ | Engine oil pressure was measured (by the MoCo) with a pressure gauge at the oil pump. \\ | ||
Expected oil pump pressure per FSM's: \\ | Expected oil pump pressure per FSM's: \\ | ||
+ | |||
===== Gauge mounted at tappet hole plug ===== | ===== Gauge mounted at tappet hole plug ===== | ||
As checked with hot oil and a gauge at the plug hole on the engine case between the tappets. \\ | As checked with hot oil and a gauge at the plug hole on the engine case between the tappets. \\ |