Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:evo:oil03i [2018/12/24 01:25] hippysmack [86-90 Oil Pump (26204-86) Individual Parts and Pics] |
techtalk:evo:oil03i [2018/12/24 05:39] hippysmack [Gearshaft Pins] |
||
---|---|---|---|
Line 64: | Line 64: | ||
The installed lower pin also holds the outer plate in the pump body. \\ | The installed lower pin also holds the outer plate in the pump body. \\ | ||
The length of this pin could be a potential issue under the right conditions. \\ | The length of this pin could be a potential issue under the right conditions. \\ | ||
- | Too short and it could get make it's way into the hole in the plate and tear the seal. \\ | + | Too short and it could get make it's way into the hole in the plate and upset the center of the pressed in seal. \\ |
This could induce slop in the plate and allow it to try to spin the plate against the roll pin in the body. \\ | This could induce slop in the plate and allow it to try to spin the plate against the roll pin in the body. \\ | ||
As well as create a leak from the feed side and allow oil to float up into the engine thru the gearshaft bore. \\ | As well as create a leak from the feed side and allow oil to float up into the engine thru the gearshaft bore. \\ |