Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:evo:oil03i [2018/12/24 01:25]
hippysmack [86-90 Oil Pump (26204-86) Individual Parts and Pics]
techtalk:evo:oil03i [2018/12/24 05:39] (current)
hippysmack [Gearshaft Pins]
Line 64: Line 64:
 The installed lower pin also holds the outer plate in the pump body. \\ The installed lower pin also holds the outer plate in the pump body. \\
 The length of this pin could be a potential issue under the right conditions. \\ The length of this pin could be a potential issue under the right conditions. \\
-Too short and it could get make it's way into the hole in the plate and tear the seal. \\+Too short and it could get make it's way into the hole in the plate and upset the center of the pressed in seal. \\
 This could induce slop in the plate and allow it to try to spin the plate against the roll pin in the body. \\ This could induce slop in the plate and allow it to try to spin the plate against the roll pin in the body. \\
 As well as create a leak from the feed side and allow oil to float up into the engine thru the gearshaft bore. \\  As well as create a leak from the feed side and allow oil to float up into the engine thru the gearshaft bore. \\