Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:priclutch01 [2019/07/10 14:54] hippysmack [Clutch Release Adjustment - Why & How] |
techtalk:evo:priclutch01 [2019/08/16 17:12] ixl2relax [Clutch Design & Operation] |
||
---|---|---|---|
Line 49: | Line 49: | ||
On the other hand, for 1991-1993 models, which also have five-speed transmissions, while the clutch operation is the same, the Ball & Ramp Assembly is mounted to the inside of the Primary Cover (as illustrated for 1984L-1990 four-speed models). This necessitates the removal of the Primary Cover in order to replace either the B&R unit or the Adjuster Bearing unit on those models. | On the other hand, for 1991-1993 models, which also have five-speed transmissions, while the clutch operation is the same, the Ball & Ramp Assembly is mounted to the inside of the Primary Cover (as illustrated for 1984L-1990 four-speed models). This necessitates the removal of the Primary Cover in order to replace either the B&R unit or the Adjuster Bearing unit on those models. | ||
+ | |||
+ | **Also note** that the clutch diaphragm spring for 883 models changed (883=P/N 37910-04B & 1200=P/N 37924-04A). From 2004-later, the 883 models used a lighter diaphragm spring, while previously, both the 883 & 1200 models were the same (P/N 36792-91). | ||
\\ | \\ | ||
+ | |||
===== Removing the Clutch Pack - 5-Speed ===== | ===== Removing the Clutch Pack - 5-Speed ===== | ||
Line 155: | Line 158: | ||
**Side note**: \\ | **Side note**: \\ | ||
- | It may be difficult to feel the right spot while turning the screw. ((Tomcatt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5761621&highlight=clutch#post5761621 )) \\ | + | It may be difficult to feel the right spot while turning the screw. ((Tomcatt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5761621&highlight=clutch#post5761621 )) ((thanks to Jollly Rogers for the suggestion http://xlforum.net/forums/showthread.php?p=5761695#post5761695)) \\ |
You may want to grab the release arm and check for movement where the cable attaches. \\ | You may want to grab the release arm and check for movement where the cable attaches. \\ | ||
Play (or lack of play) is obvious there as you adjust the screw. \\ Check for movement there, same direction as the cable operating the release. \\ | Play (or lack of play) is obvious there as you adjust the screw. \\ Check for movement there, same direction as the cable operating the release. \\ |