Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:priclutch01 [2019/07/10 14:54] hippysmack [Clutch Release Adjustment - Why & How] |
techtalk:evo:priclutch01 [2019/08/16 17:30] ixl2relax [Upgrade Clutch Diaphragm Springs - Pressure] |
||
|---|---|---|---|
| Line 49: | Line 49: | ||
| On the other hand, for 1991-1993 models, which also have five-speed transmissions, while the clutch operation is the same, the Ball & Ramp Assembly is mounted to the inside of the Primary Cover (as illustrated for 1984L-1990 four-speed models). This necessitates the removal of the Primary Cover in order to replace either the B&R unit or the Adjuster Bearing unit on those models. | On the other hand, for 1991-1993 models, which also have five-speed transmissions, while the clutch operation is the same, the Ball & Ramp Assembly is mounted to the inside of the Primary Cover (as illustrated for 1984L-1990 four-speed models). This necessitates the removal of the Primary Cover in order to replace either the B&R unit or the Adjuster Bearing unit on those models. | ||
| + | **Also note** that the stock clutch diaphragm spring for both 883 & 1200 models was the same from '84-'90 (36792-84) and from 1991 to 2003 (36792-91). From 2004-later, the 883 models used a lighter diaphragm spring: 883 uses 37910-04B & 1200 uses 37924-04A. | ||
| \\ | \\ | ||
| + | |||
| ===== Removing the Clutch Pack - 5-Speed ===== | ===== Removing the Clutch Pack - 5-Speed ===== | ||
| Line 155: | Line 157: | ||
| **Side note**: \\ | **Side note**: \\ | ||
| - | It may be difficult to feel the right spot while turning the screw. ((Tomcatt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5761621&highlight=clutch#post5761621 )) \\ | + | It may be difficult to feel the right spot while turning the screw. ((Tomcatt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5761621&highlight=clutch#post5761621 )) ((thanks to Jollly Rogers for the suggestion http://xlforum.net/forums/showthread.php?p=5761695#post5761695)) \\ |
| You may want to grab the release arm and check for movement where the cable attaches. \\ | You may want to grab the release arm and check for movement where the cable attaches. \\ | ||
| Play (or lack of play) is obvious there as you adjust the screw. \\ Check for movement there, same direction as the cable operating the release. \\ | Play (or lack of play) is obvious there as you adjust the screw. \\ Check for movement there, same direction as the cable operating the release. \\ | ||
| Line 284: | Line 286: | ||
| ===== Upgrade Clutch Diaphragm Springs - Pressure ===== | ===== Upgrade Clutch Diaphragm Springs - Pressure ===== | ||
| + | |||
| + | Below are a list of upgrade versions. The 'xx% stronger' are claimed values by the respective vendors. | ||
| **L1984-90 Sportster** | **L1984-90 Sportster** | ||
