Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:priclutch01 [2019/08/16 17:00] ixl2relax [Clutch Design & Operation] |
techtalk:evo:priclutch01 [2019/08/16 17:31] ixl2relax [Clutch Design & Operation] |
||
---|---|---|---|
Line 48: | Line 48: | ||
On the other hand, for 1991-1993 models, which also have five-speed transmissions, while the clutch operation is the same, the Ball & Ramp Assembly is mounted to the inside of the Primary Cover (as illustrated for 1984L-1990 four-speed models). This necessitates the removal of the Primary Cover in order to replace either the B&R unit or the Adjuster Bearing unit on those models. | On the other hand, for 1991-1993 models, which also have five-speed transmissions, while the clutch operation is the same, the Ball & Ramp Assembly is mounted to the inside of the Primary Cover (as illustrated for 1984L-1990 four-speed models). This necessitates the removal of the Primary Cover in order to replace either the B&R unit or the Adjuster Bearing unit on those models. | ||
- | |||
- | \\ | ||
- | |||
- | Also note that the clutch pressure plate for 883 models changed in 2004. From 2004-later, the 883 models used a lighter clutch pressure plate, while previously, both the 883 & 1200 models were the same.((http://hammerperf.com/883conversions.shtml)) | ||
\\ | \\ | ||
Line 288: | Line 284: | ||
===== Upgrade Clutch Diaphragm Springs - Pressure ===== | ===== Upgrade Clutch Diaphragm Springs - Pressure ===== | ||
+ | |||
+ | Below are a list of upgrade versions. The 'xx% stronger' are claimed values by the respective vendors. | ||
**L1984-90 Sportster** | **L1984-90 Sportster** |