Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:priclutch02 [2018/08/13 03:56] ixl2relax [Sprocket Mounting Torques] |
techtalk:evo:priclutch02 [2018/08/13 03:59] ixl2relax [Sprocket Torquing] |
||
|---|---|---|---|
| Line 65: | Line 65: | ||
| Use regular six-sided sockets which are less likely to slip and round off the edges of the nuts. Impact-type sockets are likely too thick to fit. | Use regular six-sided sockets which are less likely to slip and round off the edges of the nuts. Impact-type sockets are likely too thick to fit. | ||
| - | When lossening or tightening these nuts, you will need to **lock the hub & sprocket** - Do not wedge the chain.\\ | + | When lossening or tightening these nuts, you will need to **lock the hub & sprocket** - Do not wedge the chain. |
| - | Buy a primary locking tool (bar) or use a closed 4" BRASS hinge as a wedge. (Place the wedge so as not to put\\ | + | |
| - | pressure on the shifter shaft)\\ There are also several 4 and 5 speed [[techtalk:ref:tools116#engine_and_clutch_sprocket_locking_tools|primary locking tool examples]] in the tool section.\\ | + | Buy a primary locking tool (bar) or use a closed 4" BRASS hinge as a wedge. (Place the wedge so as not to put pressure on the shifter shaft)\\ There are also several 4 and 5 speed [[techtalk:ref:tools116#engine_and_clutch_sprocket_locking_tools|primary locking tool examples]] in the tool section. |
| + | |||
| + | \\ | ||
| {{:techtalk:evo:priclutch:primary-brasshinge-lock.jpg?400|}} ((Scuba10jdl http://xlforum.net/forums/showthread.php?t=53268)) | {{:techtalk:evo:priclutch:primary-brasshinge-lock.jpg?400|}} ((Scuba10jdl http://xlforum.net/forums/showthread.php?t=53268)) | ||
