Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:priclutch02 [2018/08/13 03:56] ixl2relax [Sprocket Mounting Torques] |
techtalk:evo:priclutch02 [2018/12/16 00:44] ixl2relax [Primary Chain Tensioner] |
||
---|---|---|---|
Line 47: | Line 47: | ||
|{{:techtalk:evo:priclutch:primarychainadjuster-compoldnew.jpg|}}| | |{{:techtalk:evo:priclutch:primarychainadjuster-compoldnew.jpg|}}| | ||
- | | Upgrade 39975-90A - Upgrade for 91-later XLH Primary Chain Tensioner ((photo by aswracing - http://xlforum.net/forums/showthread.php?t=1627892)) | | + | | Upgrade 39975-90A should be used in place of 1991-2000 stock Chain Tensioner.\\ 2001-later models used -90A part as stock ((photo by aswracing - http://xlforum.net/forums/showthread.php?t=1627892)) | |
\\ | \\ | ||
Line 65: | Line 65: | ||
Use regular six-sided sockets which are less likely to slip and round off the edges of the nuts. Impact-type sockets are likely too thick to fit. | Use regular six-sided sockets which are less likely to slip and round off the edges of the nuts. Impact-type sockets are likely too thick to fit. | ||
- | When lossening or tightening these nuts, you will need to **lock the hub & sprocket** - Do not wedge the chain.\\ | + | When lossening or tightening these nuts, you will need to **lock the hub & sprocket** - Do not wedge the chain. |
- | Buy a primary locking tool (bar) or use a closed 4" BRASS hinge as a wedge. (Place the wedge so as not to put\\ | + | |
- | pressure on the shifter shaft)\\ There are also several 4 and 5 speed [[techtalk:ref:tools116#engine_and_clutch_sprocket_locking_tools|primary locking tool examples]] in the tool section.\\ | + | Buy a primary locking tool (bar) or use a closed 4" BRASS hinge as a wedge. (Place the wedge so as not to put pressure on the shifter shaft)\\ There are also several 4 and 5 speed [[techtalk:ref:tools116#engine_and_clutch_sprocket_locking_tools|primary locking tool examples]] in the tool section. |
+ | |||
+ | \\ | ||
{{:techtalk:evo:priclutch:primary-brasshinge-lock.jpg?400|}} ((Scuba10jdl http://xlforum.net/forums/showthread.php?t=53268)) | {{:techtalk:evo:priclutch:primary-brasshinge-lock.jpg?400|}} ((Scuba10jdl http://xlforum.net/forums/showthread.php?t=53268)) | ||