Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:susp01 [2019/02/21 00:18] ixl2relax [1986-2003 Forks (Except 1200S)] |
techtalk:evo:susp01 [2019/07/10 19:19] ixl2relax [Fork Oil Drain Screws] |
||
---|---|---|---|
Line 115: | Line 115: | ||
\\ | \\ | ||
- | Spring Rates: | + | Spring Rates:\\ |
45372-92 - 21.5" - 47coils - Rate reported as 40#/in ((by sebasbecu at xlforum.net/forums/showthread.php?t=2072495)) | 45372-92 - 21.5" - 47coils - Rate reported as 40#/in ((by sebasbecu at xlforum.net/forums/showthread.php?t=2072495)) | ||
Line 206: | Line 206: | ||
^ 2016 | 1200V (72) | 45500280 | 45500283 | 45500276 | 45500281 | 45500279 | 45500277 | | ^ 2016 | 1200V (72) | 45500280 | 45500283 | 45500276 | 45500281 | 45500279 | 45500277 | | ||
^ 2017-2018 | 1200X (48) | 45500295 | 45500296 | 45500293 | 45500295 | 45500298 | 45500294 | | ^ 2017-2018 | 1200X (48) | 45500295 | 45500296 | 45500293 | 45500295 | 45500298 | 45500294 | | ||
+ | |||
+ | \\ | ||
+ | Here's a thread by 'Tomcatt' of the XLForum regarding changing to aftermarket springs & changing the oil viscosity/level in these mixed-tech forks:\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=2073068 | ||
+ | |||
+ | \\ | ||
Line 290: | Line 296: | ||
====== Fork Oil Drain Screws ====== | ====== Fork Oil Drain Screws ====== | ||
- | 45790-80 - Stock Philips-head Drain Screw with Washer (Requires 1 for each fork)\\ | + | 45790-80 - Stock __JIS-head__ Drain Screw with Washer (Requires 1 for each fork)\\ |
* (Starting in 2008, some models do not have fork oil drain screws) | * (Starting in 2008, some models do not have fork oil drain screws) | ||
+ | * (Use a JIS screwdriver for JIS screws. JIS screws look like Philips screws, but the JIS version is a wider blade with different spline angles. Using a Philips screwdriver on a JIS screw will often round out the screw head. However, using a JIS screwdriver on a Philips-head screw may work just fine, since the driver splines fit snugly on the upper, heavier part of the screw head.) | ||
45815-03 - Chrome Fork Slider Drain Screw Kit((Folkie - xlforum.net/forums/showthread.php?t=738626))\\ | 45815-03 - Chrome Fork Slider Drain Screw Kit((Folkie - xlforum.net/forums/showthread.php?t=738626))\\ |