Table of Contents
This is an old revision of the document!
EVO: Suspension - Sub-03E
Dimensions for Rigid Mount Swingarm and Parts
Bearing Lockring
Used on 1982-2003, all models.
This is the ring installed in the groove in the swingarm between the 2 bearing races.
It has no part number as it comes in a set with the bearings.
It's actually just a retaining ring acting as both a stop and a spacer between each bearing race when they are installed.
Bearing Spacer
Used on 1982-2003, all models.
This is the ring installed between the two inner bearing races (and inside the lockring).
It has no part number as it comes in a set with the bearings.
Pivot Bolt Spacer
Used on 1986-2003, all models.
Part# (5741)
This bushing sets the length measurement for the proper clamp force on the swingarm part assembly and acts as a spacer bushing thru the left pivot.