Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:trouble01 [2020/01/07 19:07] ixl2relax [Setting TSM/HFSM and ECM Password] |
techtalk:evo:trouble01 [2021/07/30 01:55] ixl2relax [ECM Password Learn Procedure] |
||
---|---|---|---|
Line 9: | Line 9: | ||
====== ECM Password Learn Procedure ====== | ====== ECM Password Learn Procedure ====== | ||
- | The TSM/TSSM modules share a password with the ECM on fuel injected bikes (and ICM's on early rubber mount bikes). When replacing an ECM/ICM or TSSM, you must go through a password learn procedure. If the procedure is not followed, the engine will start and run for a few seconds, and then stall. This will typically throw a P1009 diagnostic code. | + | The TSM/TSSM modules share a password with the ECM on fuel injected bikes (and ICM's on early rubber mount bikes). When replacing an ECM/ICM or TSSM or Speedometer, you must go through a password learn procedure. If the procedure is not followed, the engine will start and run for a few seconds, and then stall. This will typically throw a P1009 diagnostic code. |
The learn procedure MUST be followed from start to finish without any interruption. If interrupted, starting over from the beginning is the only option. | The learn procedure MUST be followed from start to finish without any interruption. If interrupted, starting over from the beginning is the only option. | ||
Line 15: | Line 15: | ||
**Connect the motorcycle up to a trickle charger and pull the headlight fuse before starting these steps, which take more than 30 minutes to complete.** | **Connect the motorcycle up to a trickle charger and pull the headlight fuse before starting these steps, which take more than 30 minutes to complete.** | ||
- | For information about removing/replacing the TSM/TSSM, click this [[http://xlforum.net/forums/showthread.php?t=573200|XLForum Thread]] by Cosmo on the topic. | + | For information about removing/replacing the TSM/TSSM, click this [[http://xlforum.net/forums/showthread.php?t=573200|XLForum Thread]] by XLForum member 'Cosmo Kramer' on the topic. |
^ Device Replaced ^ Password Learn\\ Procedure Required? | ((See 2007 Harley-Davidson Sportster Electrical Diagnostic Manual Section 3.25, pg 3-72)) | | ^ Device Replaced ^ Password Learn\\ Procedure Required? | ((See 2007 Harley-Davidson Sportster Electrical Diagnostic Manual Section 3.25, pg 3-72)) | | ||
Line 41: | Line 41: | ||
| 11 | Quickly (within two seconds) turn **IGN** key OFF-**ON**. | | ECM must not be allowed to shutdown. || | | 11 | Quickly (within two seconds) turn **IGN** key OFF-**ON**. | | ECM must not be allowed to shutdown. || | ||
| 12 | Turn **IGN** key **OFF**. __Wait 15 seconds before turning IGN on__. Turn **IGN** switch **ON** and start engine to confirm successful Password Learn procedure. Clear diagnostic trouble codes. | | || | | 12 | Turn **IGN** key **OFF**. __Wait 15 seconds before turning IGN on__. Turn **IGN** switch **ON** and start engine to confirm successful Password Learn procedure. Clear diagnostic trouble codes. | | || | ||
- | | 13 | If the learn procedure is interrupted or fails in any way, you must restart your attempt from the beginning of the procecure |||| | + | | 13 | If the learn procedure is interrupted or fails in any way, you must restart your attempt from the beginning of the procecure! |||| |
(This section contributed by Screw Loose Dan ) | (This section contributed by Screw Loose Dan ) |