Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:trouble01 [2020/01/07 19:06] ixl2relax [Setting TSM/HFSM and ECM Password] |
techtalk:evo:trouble01 [2020/01/07 19:07] ixl2relax [Setting TSM/HFSM and ECM Password] |
||
|---|---|---|---|
| Line 30: | Line 30: | ||
| | | Ignition must be turned off for at least 15 seconds. | With ignition turned off, Check Engine Lamp and Security Lamp will be off. | Remember to pull the headlight fuse. || | | | Ignition must be turned off for at least 15 seconds. | With ignition turned off, Check Engine Lamp and Security Lamp will be off. | Remember to pull the headlight fuse. || | ||
| | 1 | Install new TSM/HFSM or ECM. | | || | | 1 | Install new TSM/HFSM or ECM. | | || | ||
| - | | 2 | Set **RUN/OFF** switch to **RUN**. | | || | + | | 2 | Set **RUN/STOP** switch to **RUN**. | | || |
| | 3 | Turn **IGN** key **ON**. | Verify Check Engine Lamp and Security Lamp illuminate and then turn off. | TSM/HFSM enables starter relay.|| | | 3 | Turn **IGN** key **ON**. | Verify Check Engine Lamp and Security Lamp illuminate and then turn off. | TSM/HFSM enables starter relay.|| | ||
| | 4 | Attempt normal start **one** time. | Engine starts and stalls. Check Engine Lamp illuminates and stays on. | Password has not been learned. ECM sets DTC P1009. || | | 4 | Attempt normal start **one** time. | Engine starts and stalls. Check Engine Lamp illuminates and stays on. | Password has not been learned. ECM sets DTC P1009. || | ||
