Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:trouble01 [2020/01/07 19:06] ixl2relax [Setting TSM/HFSM and ECM Password] |
techtalk:evo:trouble01 [2021/06/28 07:51] ixl2relax |
||
---|---|---|---|
Line 15: | Line 15: | ||
**Connect the motorcycle up to a trickle charger and pull the headlight fuse before starting these steps, which take more than 30 minutes to complete.** | **Connect the motorcycle up to a trickle charger and pull the headlight fuse before starting these steps, which take more than 30 minutes to complete.** | ||
- | For information about removing/replacing the TSM/TSSM, click this [[http://xlforum.net/forums/showthread.php?t=573200|XLForum Thread]] by Cosmo on the topic. | + | For information about removing/replacing the TSM/TSSM, click this [[http://xlforum.net/forums/showthread.php?t=573200|XLForum Thread]] by XLForum member 'Cosmo Kramer' on the topic. |
^ Device Replaced ^ Password Learn\\ Procedure Required? | ((See 2007 Harley-Davidson Sportster Electrical Diagnostic Manual Section 3.25, pg 3-72)) | | ^ Device Replaced ^ Password Learn\\ Procedure Required? | ((See 2007 Harley-Davidson Sportster Electrical Diagnostic Manual Section 3.25, pg 3-72)) | | ||
Line 30: | Line 30: | ||
| | Ignition must be turned off for at least 15 seconds. | With ignition turned off, Check Engine Lamp and Security Lamp will be off. | Remember to pull the headlight fuse. || | | | Ignition must be turned off for at least 15 seconds. | With ignition turned off, Check Engine Lamp and Security Lamp will be off. | Remember to pull the headlight fuse. || | ||
| 1 | Install new TSM/HFSM or ECM. | | || | | 1 | Install new TSM/HFSM or ECM. | | || | ||
- | | 2 | Set **RUN/OFF** switch to **RUN**. | | || | + | | 2 | Set **RUN/STOP** switch to **RUN**. | | || |
| 3 | Turn **IGN** key **ON**. | Verify Check Engine Lamp and Security Lamp illuminate and then turn off. | TSM/HFSM enables starter relay.|| | | 3 | Turn **IGN** key **ON**. | Verify Check Engine Lamp and Security Lamp illuminate and then turn off. | TSM/HFSM enables starter relay.|| | ||
| 4 | Attempt normal start **one** time. | Engine starts and stalls. Check Engine Lamp illuminates and stays on. | Password has not been learned. ECM sets DTC P1009. || | | 4 | Attempt normal start **one** time. | Engine starts and stalls. Check Engine Lamp illuminates and stays on. | Password has not been learned. ECM sets DTC P1009. || |