Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:carb01 [2018/04/18 00:53] ixl2relax |
techtalk:ih:carb01 [2019/09/01 16:44] hippysmack [Mikuni (general application)] |
||
---|---|---|---|
Line 256: | Line 256: | ||
|38mm Carb Types|Main|Pilot|Needle Jet|Throttle Valve|Jet Needle|Air Jet| | |38mm Carb Types|Main|Pilot|Needle Jet|Throttle Valve|Jet Needle|Air Jet| | ||
|VM38-9 (43mm spigot)((IronMick http://xlforum.net/forums/showthread.php?t=2006195&page=2))|330|30|Q-2|2.5|6DP1|0.5| | |VM38-9 (43mm spigot)((IronMick http://xlforum.net/forums/showthread.php?t=2006195&page=2))|330|30|Q-2|2.5|6DP1|0.5| | ||
+ | |||
+ | See more on the [[techtalk:ref:carb02#vm_series|Mikuni VM-38]] in the REF section of the Sportsterpedia. \\ | ||
---- | ---- | ||
Line 313: | Line 315: | ||
---- | ---- | ||
- | ===== Keihin non-CV Carb (Late 1976-1987) ===== | + | ===== Keihin "butterfly" or "non-CV" Carb (Late 1976-1987) ===== |
+ | * . . . [[techtalk:ih:carb01a|Origin of the Keihin BH Carburetor]] | ||
+ | |||
* The Keihin non-CV carburetor is a horizontal type with a fuel bowl, single ring-shaped float, an accelerating pump, idle mixture adjusting needle and a throttle stop screw for speed adjustment. ((1970-1978 HD XL/XLH/XLCH/XLT 1000 FSM)) | * The Keihin non-CV carburetor is a horizontal type with a fuel bowl, single ring-shaped float, an accelerating pump, idle mixture adjusting needle and a throttle stop screw for speed adjustment. ((1970-1978 HD XL/XLH/XLCH/XLT 1000 FSM)) | ||
* The throttle body casting contains an integral venture and a fuel valve seat that is pressed into the body. The underside of the throttle body contains a boss. The main jet screws into the boss and holds the bleed tube in place.((1970-1978 HD XL/XLH/XLCH/XLT 1000 FSM)) | * The throttle body casting contains an integral venture and a fuel valve seat that is pressed into the body. The underside of the throttle body contains a boss. The main jet screws into the boss and holds the bleed tube in place.((1970-1978 HD XL/XLH/XLCH/XLT 1000 FSM)) |